09-03-2002 1 of 10 K6858553
DEF
C
2x
B
A
RB1 NAVIGATION RADIO
CHRYSLER
PT CRUISER . . . . . . . . . . . . .2
300M . . . . . . . . . . . . . . . . . . . .3
CONCORDE . . . . . . . . . . . . . .4
SEBRING . . . . . . . . . . . . . . . .5
TOWN & COUNTRY . . . . . . . .6
DODGE
INTREPID . . . . . . . . . . . . . . . .4
STRATUS . . . . . . . . . . . . . . . .5
CARAVAN . . . . . . . . . . . . . . . .6
DURANGO/DAKOTA . . . . . . . .7
RAM . . . . . . . . . . . . . . . . . . . .8
JEEP
LIBERTY . . . . . . . . . . . . . . . . .9
GRAND CHEROKEE . . . . . .10
GB ■Disconnect and isolate negative battery cable.
■Remove interior trim panels in the order shown.
■Disconnect and remove existing radio. Replace with item C.
■Install GPS antenna as shown to receive an unblocked signal from the satellites.
■Keep GPS antenna cable away from heat sources, sharp edges, or moving parts.
■Do not bend (more than 90°), kink, or tightly coil the GPS antenna cable.
■Apply mercury warning label (Item D) to the B-pillar as shown.
F■Débrancher et isoler le câble négatif de la batterie.
■Retirer les panneaux d'habillage intérieurs dans l'ordre indiqué.
■Débrancher et retirer la radio existante. La remplacer par l'article C.
■Installer l'antenne GPS comme illustré afin qu'elle puisse recevoir les signaux satellite sans aucun blocage.
■Garder le câble de l'antenne GPS à l'écart des sources de chaleur, bords acérés et pièces mobiles.
■Ne pas plier (à plus de 90º), vriller ou enrouler de façon serrée le câble de l'antenne GPS.
■Apposer l'autocollant d'avertissement de température (article D) sur le montant B, comme illustré.