Mophie Powerstation go ac User manual

SAFETY PRECAUTIONS

DANGER-CAUTION Read and understand all safety information

before using this product. Failure to follow these instructions may

result in electrical shock, explosion, re which may result in serious

injuries, death or property damage.

• When used correctly, lithium- ion rechargeable batteries provide a

safe and dependable source of portable power. However, if they are

misused or abused, this may result in leakage, burns, re or explosion,

causing personal injury or damage to other devices.

• Misusing or incorrectly connecting your powerstation go AC may

cause electric shock to users and damage equipment.

• Do not operate in explosive atmospheres such as in the presence of

ammable liquids, gases or dust.

• Remove jump start clamps from vehicle battery after jump starting vehicle.

• Keep your powerstation go AC dry and away from moisture and

corrosive materials. The powerstation go AC should not be used near

water or wet areas such as bathtubs, showers, bathrooms, sinks,

swimming pools or basements.

• Do not expose your powerstation go AC to moisture, water, rain, or snow.

• Keep your powerstation go AC away from heat sources, including

open ames, radiators, stoves, ovens, and any other devices that

product heat.

• The lithium-ion rechargeable battery used in this charging

device may present a risk of re or chemical burn if mistreated. Do not

expose to re or excessive temperature. Do not expose to heat above

212°F (100°C) or incinerate.

• In the unlikely event of leakage or explosion use sand or a chemical

re extinguisher.

• Your powerstation go AC may become warm under extended high

power operation. Do not cover, wrap, or otherwise restrict the

powerstation go AC during operation.

• Do not disassemble your powerstation go AC. There are no user-

serviceable parts inside. Incorrect reassembly may result in shock

or re hazard.

• Do not drop or subject to strong impacts. Do not operate your

powerstation go AC if it has received a sharp blow, or has otherwise

been damaged in any way.

• Do not puncture, crush or subject to mechanical shock.

• Only charge your powerstation go AC by the specied method with

the specied charging adapter provided with the unit.

• Do not use any non-mophie-branded accessories with the

powerstation go AC. Doing so may cause electric shock to users and

damage equipment.

• The powerstation go AC, along with its accessories, are not toys and

should be kept away from children.

• Make sure the jumper cables are fully plugged into the jump start

output before trying to jumpstart your vehicle.

• Do not touch red (positive) and black (negative) jumper clamps

together at any point.

• Do not insert any foreign object into the ports or openings of your

powerstation go AC.

• Do not clean your powerstation go AC with harsh chemicals, soaps or

detergents. Just wipe the case with a soft cloth.

• Make sure the powerstation go AC’s charging ports do not become

contaminated with lint or other debris. Use a canned-air type of

product periodically to ensure that the port openings are clear.

• Batteries should be recycled or disposed of as per state and

local guidelines.

• Storage: -4°F – 158°F (-20°C – 70°C), Discharge: 14°F – 122°F

(-10°C – 50°C), Charge: 32°F – 113°F (0°C – 45°C)

OPERATING INSTRUCTIONS

Charging Your powerstation go AC

To charge your powerstation go AC, use the provided Wall Charging

Adapter, and plug the DC jack into the charging put. Next, connect the

wall charging adapter into a wall outlet. The powerstation go AC will

automatically begin charging. When the powerstation go AC is fully

charged, all ve battery indicator bars will be solid white and the digital

screen will indicate 100% charged. (This could take up to 9 hours).

While charging, the digital screen will illustrate the charge percentage

of the powerstation go AC. When fully charged, disconnect the cable.

NOTE:

The powerstation go AC is designed to charge between 32°F-113°F

(0-45° C). A "TEMP" indicator will be illustrated on the digital display if

the powerstation go AC is attempted to be charged outside of this

temperature range.

JUMP STARTING YOUR VEHICLE WITH

THE POWERSTATION GO AC

1. Plug the jumper cables into the jump start output on the

powerstation go AC.

2. Attach the jumper cable clamps to the vehicle battery.

- Red clamp on positive terminal (+)

- Black clamp on negative terminal (-)

CHARGING AN ELECTRONIC DEVICE USING

5V/2.4A USB OUTPUT PORT

1. Connect the USB-C tip of the supplied USB-C cable into the

USB-C input of your electronic device and connect the Standard

USB end of the supplied USB-C cable into either one of the

powerstation go AC USB 5V/2.4A Output ports.

2. Turn on the USB charging by pressing the

USB Power ON/OFF Button on the powerstation go AC.

SPECIFICATIONS

Battery Cells: Contains a battery with 3x Li-Polymer 5000mAh

Battery Pack Energy: 55500 mWh

Jump Start: 12V/600Amps

Input: 14V/0.85A

USB Output: 2x USB 5V/2.4A

Dimensions: 3.82 x 7.17 x 1.5 inches

Weight: 1.66 lbs

Operating Temperature (During Charging) 32°F - 113°F (0°C - 45°C)

Operating Temperature 14°F - 122°F (-10°C - 50°C)

COMPLIANCE WITH FCC REGULATION

This device complies with part 15 of the FCC Rules and RSS-Gen of IC

Rules. Operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may

cause undesired operation.

NOTE: This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment o and

on, the user is encouraged to try to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dierent from that

to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

CAUTION: To comply with the limits of the Class B digital device,

pursuant to Part 15 of the FCC Rules, this device must be used with

certied peripherals and shielded cables. All peripherals must be

shielded and grounded. Operation with non-certied peripherals or

non-shielded cables may result in interference to radio or reception.

LIMITED WARRANTY

At mophie, we are dedicated to making the best quality products. To

back this up, this product is warranted for 90 days. For full details

regarding warranty terms, exclusions and limitations, please visit:

mophie.com/warranty. This warranty does not aect any statutory

rights that you may be entitled to. Keep a copy of your purchase receipt

as proof of purchase. Be sure to register your product at mophie.com.

MOPHIE SMART CHARGE TECHNOLOGY

Your powerstation go AC contains the mophie SMART CHARGE

TECHNOLOGY to achieve higher compatibility for charging standard 5V

USB electronic devices. The mophie SMART CHARGE TECHNOLOGY will

allow the powerstation go AC to communicate with your electronic

device and provide the fastest and safest charge for that device.

COMPATIBILITY

Standard 5V USB electronic devices including: Mobile phones, Tablets,

PSP, NDS, MP3, MP4, MP5, Bluetooth, GPS, Cameras, and more.

USING YOUR POWERSTATION GO AC FLOODLIGHT

The oodlight can be turned on and o by simply pressing and

releasing the oodlight ON/OFF button. The rst press will turn on the

oodlight. Second press will turn on the red emergency light. Third

press will turn on SOS ashing red light. The oodlight will

automatically turn o after 2 hours of inactivity.

JUMP START TROUBLESHOOTING TIPS

3. Press the “Jump Start” button and wait for solid green light.

4. Start your vehicle.

5. Disconnect the jumper cable clamps from the car battery.

powerstation®go AC

OPERATING INSTRUCTIONS

powerstation go AC

Thank you for choosing mophie!

Powerful and loaded with features including a new, easy to use digital

display, the powerstation go AC can be used to safely jump start your

vehicle or provide portable power for your AC appliances. The

powerstation go AC can charge your laptop, phone, tablet and other

electronic devices anywhere! The powerstation go AC also includes a

convenient oodlight and emergency light. Compact, versatile and

simple to use, the powerstation go AC and all accessories t neatly in its

carrying pouch and is perfect to store in your home or vehicle for every

day use or an emergency need.

TABLE OF CONTENTS

Safety Precautions

Included Items

Operating Instructions

Troubleshooting Guide

Specications

Warranty and Contact Information