Morgan MDH-PD60 User manual

USER MANUAL
Range
Hood
MDH-PD60
MDH-PD90
E-mail: [e-mail]
www.morgan.my
Market Expansion
Services by
www.dksh.com.my
facebook.com/morganappliances

32
INSTALLATION
Dur ng hood nstallat on there are a ser es of mportant factors to be taken nto cons derat on,
as outl ned below:
• Ensure all the technical information appearing on the specification plate corresponds to the
characteristics of the power supply in question (voltage and frequency).
• Comply with your local regulation’s electrical installation and evacuation of gases at all times.
• Ensure the unit is connected to the power supply via a suitable omnipolar switch with a 3mm minimum
gap between contacts.
• Do not connect the appliance to ducts used for gas evacuation of a non-electrical nature, such as boilers,
chimneys etc.
• Do not operate the appliance if the power cord or control panel appear to be damaged in any way.
• Once the unit has been installed, ensure that the power cord does not come into contact with sharp metal
edges.
• IMPORTANT: Minimum distances between the hob and hood should be strictly observed:
– 60 cm for electric hobs
– 70 cm for gas and mixed hobs.
• For optimum performance, the outlet duct should not exceed 4 metres in length, nor have more than two
90° bends, and its diameter should be at least 120mm.
Thank you for purchas ng a qual ty MORGAN appl ance. We trust that you w ll have a pleasant
exper ence w th your new product. To guarantee safety and best eff c ency, please read th s
manual carefully and keep a copy for future reference.
547/847
ø120
280
40
160
43.8
16
282/287
463
596/896
C O N T E N T S
3
4
5
5
6
7
INSTALLATION
HOOD INSTALLATION DIAGRAMS
OPERATION INSTRUCTIONS
FILTER INSTALLATION
CARE & CLEANING
TROUBLESHOOTING

4 5
OPERATION INSTRUCTIONSHOOD INSTALLATION DIAGRAMS
Two ways for nstallat on (refer to d agrams A & B)
LIGHTING SYSTEM SWITCHES
• Power ON/OFF
SWITCH OFF HOOD
• LOW SPEED for continuous & air change
in the presence of light cooker vapour
• HIGH SPEED for eliminating high cooker
vapour emission, including long duration
use
FILTER INSTALLATION
Detach the grease f lter f rst before nstall ng the act vated carbon f lter. Press on the lock and
pull t downwards.
NOTE:
Ensure filter is securely locked. A loose filter may pose a safety risk.
Two ways for nstallat on (refer to d agrams A & B)
NOTE:
• Extensible pipes are optional accessories & not supplied.
• Remove protection file before installation.
WALL INSTALLATION
• op edge of hood supported on wall) wo 8mm Ø drill
holes
470-770
A
UNDER CABINET INSTALLATION
• Opening for smoke exhaust
180/165
165/160
470/770
B

6 7
CARE & CLEANING TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE(S) SOLUTION
Light is powered on but Fan blade is jammed/obstructed Power OFF unit & contact your authorised exhaust
an is not working technician
Both light & exhaust an not Burnt light bulb Replace light bulb
working Loose power cord Detach power cord & connect again
The unit is vibrating Fan blade is jammed Power OFF unit & contact your authorised
uncontrollably Fan motor not securely installed technician
Unit is not securely attached to the Disassemble the unit & inspect ensure bracket is
bracket securely installed
Weak suction per ormance Placement distance between hood Readjust distance to 65cm – 75cm
& cook place is too ar apart
ENVIRONMENTAL PROTECTION
Waste electrical products should not be disposed o with household waste. Please recycle where acilities exist. Check with
your Local Authority or retailer or recycling advice.
This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment
(WEEE).
By ensuring this product is disposed o correctly, you will help prevent potential negative consequences or the environment
and human health, which could otherwise be caused by inappropriate waste handling o this product.
The symbol on the product indicates that this product must not be treated as household waste. Instead it shall be
handed over to the applicable collection point or the recycling o electrical and electronic equipment. Disposal must be
carried out in accordance with local environmental regulations or waste disposal.
For more detailed in ormation about treatment, recovery and recycling o this product, please contact your local city o ice,
your household waste disposal service or the shop where you purchased the product.
It s adv sable to power OFF the un t and d sconnect the power plug from the power supply
before clean ng.
REGULAR CLEANING
• Use a soft cloth moistened with hand-warm mildly soapy water or mild household cleaning detergent.
• Never use metal pads, chemical, abrasive material or stiff brush to clean the unit.
MONTHLY GREASE FILTER CLEANING
• ESSEN IAL: Monthly cleaning of the grease filter can help to prevent the risk of fire.
• he grease filter collects grease, smoke and dust. As such, the filter is directly affecting the efficiency &
performance of the cooker hood. If not cleaned, grease residue (potentially flammable) will saturate on
the filter.
• Clean it with mild household cleansing detergent.
ANNUAL CLEANING FOR ACTIVATED CARBON FILTER
• Apply SOLELY to unit that is installed as a recirculating unit (not vented to the outside).
• his filter traps odours and must be replaced at least once a year, depending on the usage frequency.
BULB REPLACEMENT
• Power OFF the unit off and disconnect power plug from the power supply.
• Detach the lamp cover by unscrewing the 2 screws.
• Unscrew the light bulb.
• Replace with the same type and rated bulb/lamp.