Morphy Richards Voyager 300 User manual

getting the best from
your new travel kettle
www.morphyrichards.com
www.morphyrichardsindia.com
0.5L
Travel Kettle (SS)
Please read and keep these instructions
Voyager 300
V a r 3 0
oy ge 0

2
•Do not let the lead run across an open
Important safety instructions
space e.g. between a low socket and
The use of any electrical appliance requires table.
the following common sense safety rules. •Do not let the lead run across a cooker
Primarily there is danger of injury or death or toaster or other hot area which might
and secondly the danger of damage to the damage the cable.
appliance. These are indicated in the text by
•Do not place the kettle where the mains
the following two conventions:
lead could fall into a sink.
WARNING: Danger to the person!
Your safety
IMPORTANT: Damage to the appliance! In
addition we offer the following safety advice. • Always pour hot water slowly and
carefully without tipping the kettle too
Location
fast to prevent splashing and spillage.
•Always keep your kettle away from the
• Extreme caution must be used when
edge of the worktop.
moving a kettle containing hot water.
•Ensure that the kettle is used on a firm,
•Do not touch hot surfaces, use handles
flat surface.
or knobs.
•Do not use the kettle outdoors or in a
•Always close the lid securely, otherwise
bathroom.
the kettle may not switch off
WARNING: Do not place the kettle onto a automatically and may spit out boiling
metal tray or metal surface whilst in use. water.
Children •Avoid contact with steam from the
spout when the water is boiling or just
•Children do not understand the
after it has switched off.
dangers associated with operating
electrical appliances. Never allow • Take care if opening the lid for re-filling
children to use this appliance. when the kettle is hot.
•Teach children to be aware of dangers •Do not fill above the MAX mark,
in the kitchen, warn them of the otherwise boiling water may be ejected.
dangers of reaching up to areas where
• Do not hold the switch in the on
they cannot see properly or should not
position or tamper with the switch to fix
be reaching.
it in the on position as this may cause
Mains lead damage to the switch-off mechanism.
•The mains lead should reach from the •Unplug from the outlet before cleaning.
socket to the base of the unit without
•Allow to cool before putting on or taking
straining the connections.
off parts and before cleaning.
•Do not let the mains lead hang over the
edge of the worktop where a child
could reach it.

Treating scalds
•Run cold water over the affected area
immediately. Do not stop to remove
clothing, get medical help quickly.
Other safety considerations
•To protect against fire, electric shock
and personal injury do not immerse
cord, plug or kettle in water or any
other liquid.
•Do not operate any appliance with a
damaged cord or plug or after the
appliance malfunctions or has been
damaged in any manner. Ring the
helpline number for advice on
examination and repair.
outlets in your home are not suitable for the
plug supplied with this appliance the plug
should be removed and the appropriate one
fitted.
IMPORTANT : THE PLUG REMOVED FROM
THE MAINS LEAD, IF SEVERED, MUST BE
DESTROYED AS A PLUG WITH A BARED
FLEXIBLE CORD IS HAZARDOUS IF
ENGAGED INTO A LIVE SOCKET OUTLET.
Should the fuse in the 13 amp plug require
changing a 13 amp BS1362 fuse must be
fitted.
WARNING: THIS APPLIANCE MUST BE
EARTHED.
• The use of attachments or tools not
recommended or sold by Morphy
Richards may cause fire, electric shock
or injury.
•Do not tamper with the connector in
any way.
•Do not use the kettle for any use other
than to boil water.
•Do not use outdoors.
•Do not place the kettle on or near a hot
gas or electric burner or in a heated
oven. Features
1 Lid
•The kettle must not be plugged to the
2 Spout
socket when being filled with water. 3 Element
•Unplug from the outlet when not in use. 4 Reset button
5 Power on neon
Electrical requirements
Check that the voltage on the rating plate of
your appliance corresponds with your
house electricity supply which must be A.C.
(Alternating current).
For appliances with fitted plug. If the socket
Using
Filling the kettle
•Wherever possible fill through the
spout, as this helps to free the filter
from limescale build-up.
3
1
2
4
3
5

•Always ensure that the level of water in Descaling
the kettle is filled to at least the IMPORTANT: This kettle must be descaled
minimum level shown on the water regularly. The frequency of descaling
gauge. depends on usage and the hardness of the
water in your area.
•Boil only as much water as you need as
this saves electricity. Excessive scale can cause the kettle to
switch off before boiling and may damage
Switching it on
the element invalidating the warranty.
•Plug in and switch on at the wall socket. It is essential that regular descaling takes
place.
• Switch the kettle on. The ‘power on’
neon, will light up. Remove hard scale using a proprietary
descaling product suitable for plastic
• When the water boils the kettle will kettles.
switch off automatically.
•If you are using the kettle for the first
time, pour away the boiled water and
refill.
•To re-boil, switch to ON again. If the
kettle has just switched off wait a
minute or so before switching it back on
again.
•If you do not put in enough water, or
switch on the kettle when it is empty,
the safety cut-out will switch off the
power automatically. If this happens,
refill and wait a few minutes for the
element to cool, then use as normal.
Filter removal (for models fitted
with removable filter)
1 Open the lid.
2 Lift the filter upwards from its location.
3 To refit the filter, slot it into the side wall
guides and press down firmly. Ensure
the filter is correctly located into the
central guide.
WARNING: Unless the filter is fitted correctly,
the kettle lid may not close and lock
securely and the kettle may not switch off
automatically.
Alternatively use citric acid crystals
(available from most pharmacies) as
follows.
1. Fill the kettle 3/4 full, boil, then unplug
the kettle (remove the cordless kettle
from the base unit) and stand it in an
empty sink or bowl.
2. Add 50gm of citric acid crystals to the
water gradually, then leave the kettle to
stand. Do not use a more concentrated
solution.
3. As soon as the effervescence subsides,
empty the kettle and rinse it thoroughly
with cold water.
4. Wipe the outside of the kettle
thoroughly with a damp cloth to remove
all traces of acid which may damage
the finish.
IMPORTANT: Ensure that the electrical
connections are completely dry before using
the kettle.
Cleaning
WARNING: Always disconnect the plug from
the mains and allow the kettle to cool before
cleaning.
Wipe the outside with a damp cloth.
4

IMPORTANT: Do not use abrasive cleaners •Name of the product
on the outside of the kettle which may •Model number as shown on the
scratch the surface.
underside of the appliance.
Helpline
If you have any difficulty with your appliance,
do not hesitate to call us. We’re more likely
to be able to help than the store from where
you bought it.
Please have the following information ready
to enable our staff to deal with your query
quickly:
Technical Data
Power Supply : AC 230V 50Hz
Wattage : 1000W
5

Morphy Richards products are intended
for household use only
Morphy Richards has a policy of
continuous improvement in product quality
and design. The Company, therefore,
reserves the right to change the
specification of its models at any time.
Products & parts are indicative only, the
actual product may differ.
Morphy Richards Ltd, Mexborough,
South Yorkshire, England, S64 8AJ