Mortuary Lift Ultimate 1000 Lift User manual

Installation
Suggestions
127 Cottage Grove Avenue S.E.
Cedar Rapids, Iowa 52403
800-628-8809 • 319-364-4910
www.mortuarylift.com

2
MORTUARY LIFT COMPANY [phone]
You have several options when installing your ULTIMATE 1000 LIFT™.
It can be mounted 1) STATIONARY
machine does not move or 2) TRACK or All-ACCESS TRACK SYSTEM,
where the lift can be moved from one location to another.
Either system can also be mounted FLUSH (directly against the
ceiling) or SUSPENDED (down from the ceiling to almost any height
using all thread & sway bracing, not shown in pictures).
Also, the Freedom Pivot can be added to both systems.
This INSTALLATION SUGGESTION
methods of installation and provides the basic guidelines of the
various types of mounting options.
Electrical requirements for this machine are a 110v 15amp
grounded outlet with surge protector placed within 5’ of the
machine. A standard 5’ cord is sent pre-installed with all station-
ary units. It is highly recommended to have the outlet, to which
the machine is plugged, wired to a wall switch for emergency
shutoff purposes.
MOUNTING OPTIONS
DO NOT RECESS TRACK
Electrical Requirements:
WARNING
These instructions are recommendations only
and are intended to provide you with some basic
guidelines for installation.
We strongly urge you to verify the proposed
details of your unique installation with a local

verify its adequacy and ensure compliance with
local codes and ordinances.

3
WWW.MORTUARYLIFT.COM
STATIONARY
INSTALLATION
on a Wood
Joist Ceiling
This machine
will lift itself to the
ceiling as shown
& described below.
 
 
 
  
drilled lag screw holes as shown.
3. While the machine is still on the ground, plug the machine
 
 
 
 
the ceiling by pressing the up button on the remote or
pendant (this keeps the hooks on the machine from
jamming or catching in the machine spools while lifting).
Be sure the straps wind up level on the spools.
 
keep the frame level and not to conform to the irregularities
of the ceiling.

4
MORTUARY LIFT COMPANY [phone]
A. Place lag screws in three corners and tighten until
 
B. Detach straps from screw hooks, tighten lag screw in the
 
frame and does not rattle. A good method is to make this
adjustment while the motor is in operation. When in
perfect alignment the motor will run smoothly and
quietly.
C. Insert and tighten the center (2) lag screws until the
metal washer touches the frame and does not rattle.
Securing
Sample:
Suspended monorail track mount
on a wood joist ceiling mounted
perpendicular to the joists

5
WWW.MORTUARYLIFT.COM
Machine Base
Circular Holes:
 
 
 
Slotted Holes:
 
 
 
 
 
DO NOT RECESS TRACK
24”
16”
on
ce
nter
9/16”
holes
2-1/2” long x 9/16” wide
(2) end slots & center slot are 16” on center - length 32”
2” on
center
apart
12”

127 Cottage Grove Avenue S.E.
Cedar Rapids, Iowa 52403
800-628-8809 • 319-364-4910
www.mortuarylift.com
