moss DESIGN VAIL User manual

VAIL
BENCH
C1 Top module x 1
C3 Leg B x 2
C2 Leg A x 2
Placement and Maintenance
Your Vail Bench is designed for indoor use on level floors.
Furniture with hard lacquer, wax polish or painted surface
should be dusted with a dry cloth. Spillages should be wiped
up as soon as possible. Our furniture will endure most tem-
peratures in the home but it is best to avoid placing furniture
next to heat sources such as radiators or fires.
Step 1
Unpack and identify the parts listed below. It is required to
have 2 people to carry and assemble the units over 50Ibs.
The assembly workspace should be a non-marring surface
such as carpet. For missing hardware pieces, visit our web-
site www.mossdesign.us
YNG TAL 14 / MFMT33 D:07.03.2022 / RN 001
H1 Bolt
(6x40mm) x 8
Mallet or Hammer
Tool Required:
Tool Provided:
T1 M4 Allen Key x 1

Step 2 - Attach the legs.
Attach the leg B C3 to the leg A C2 as shown below.
Step 3 - Fix the legs.
Fix the legs by using the mallet T2 as shown below.
C2
C2
C3
C3

Step 4 - Place legs onto the top module.
Put the top module C1 upside-down onto the floor
and place the legs onto the top module as
shown below.
Step 5 - Fix the legs by using allen bolts.
Use 8 bolts H1 to fix the legs to the top module. Tighten by using allen key T1.
C1
H1
H1
H1
H1
H1
H1 T1
H1
H1
H1
Check the rmness of the
imbus bolts every 6 months.
!

Step 6 - End of the assembly.
Lift the until to standing position carefully.
Moss Design is a trade name of a Colorado company Moss Furniture LLC
www.mossdesign.us