Motikom MPLUS PACK User manual

MPLUS PACK

2
This user manual accompanies this MPlus,
Multipurpose Communication Neckband
(hereafter referred to as the “MPlus”), and
contains important information on setup
and use.
Read the user manual carefully before using MPlus. This
particularly applies to the safety instructions. Failure to do
so may result in personal injury or damage to MPlus.
Keep the user manual for further use. Make sure to include
this user manual when passing MPlus on to third parties.
MPlus is exclusively designed as an BT Intercom, Hybrid
Dynamic Noise Cancellation (HDNC™) and hands-free
device for outdoor activities lovers, motorcyclists and travelers
etc . It isonly intendedfor private use and not suitable for
commercial purposes.
Only use MPlus as describedin this instruction manual or user
guide in “MOTIKOM” website. Any other use is considered
improper and may result in damage to property or persons.
The manufacturer or vendor cannot be held liable for
damages or injury incurred through improper or incorrectuse.
General Information
Reading and storing the user manual
Proper use

•When a paired MPlus is out of BT range while
intercom talks, you will hear a voice prompt
Neckband Device Disconnected. In this case,
MPlus will keep auto searching for the paired MPlus
for 15 minutes. When MPlus close to each other,
they will reconnect and turn on the intercom
automatically. You will hear the voice prompt
Intercom On.
If MPlus cannot auto-reconnect, you will hear the
voice prompt Neckband Device Disconnected. In
this case, you could use a manual method to initiate
the search & reconnection again, press the MFB
button once to restart MPlus for automatic pairing.

MPlus is capable of pairing with a third-party Bluetooth device
(e.g. BT headphones, BT intercom device or BT speaker).
However, the proprietary software of the third party BT device
1. Ensure the third-party BT device in the BT pairing mode.
The controls of intercom calls between MPlus and the third-party
BT device must be performed on MPlus only.
2. Press and hold MFB and HDNC™ buttons same time and then
release the buttons when you hear the VP “Intercom pairing”.
Then Mplus will initiate the paring search for the third-party BT
device automatically. You will hear the VP “Neckband device
connected” when MPlus is paired with the third-party BT device
successfully.
9.3 Pairing with compatible Bluetooth
devices for Intercom Communication
Paired
NormalHeadphone
20
or
Paired
or
MPlus
BT Speaker
MPlus
&