Moto MOTO Urban Pedal User manual

Please read this manual properly before use and follow all the
instructions carefully.
Once you have read the manual you should store it in a safe
place for future reference.
You should only disassemble the pedals if you are familiar with
the technology and if you have all the necessary tools at hand.
Motobicycles-36 UG
Berlin, Germany
www.motobicycles.com
[email protected]
Tel.: +49 (0) 30 / 6981 9089
Urban Cycling Pedal
Manual
Contents
Initial adjustments
Construction
Thank you for choosing the MOTO pedal. This manual has been
designed to assist you with technical support. Should you have
any questions please check this manual and if necessary contact
an experienced bicycle mechanic or the MOTO customer
support team.
The MOTO pedal is manufactured completely in Germany to
the highest quality requirements and assembled carefully by hand.
However, should you have reason to complain please contact
your bicycle dealer or the MOTO customer support team.
Clean the crank
Dismount the current pedals
Clean the thread of the pedal crank arm thoroughly
1.
2.
3.
Grip tape pad
Grip tape pad
4 Grip tape pads
2 Pedals
Screws
Plastic
half-shell
Threaded
metal shaft
Moto quality Safety notes
Allen key 3 mm 2 Stickers
Please tighten the screws of the plastic half-shells with a torque
of 120-150 Ncm. You can use the 3 mm Allen key, included in
the package.
Plastic
half-shell
Wooden frame
Screws
Screws
O-Ring
Nuts
Nuts
20120917_MOT_PEDAL_MANUAL_ENGLISH_NR21_FIN.indd 1 17.09.2012 18:43:39

Fastening
Assembly tool
Right pedal
When mounting the pedal, please follow the installation
instructions and the suggested torque strength given by the
crank arm manufacturer!
Attention! The right pedal has a right hand thread and the left
pedal has a left hand thread at the pedal shaft for mounting on
the crank arm.
Left pedal
The pedal shaft terminates
in an 8 mm hex socket.
An 8 mm Allen key is needed
to mount the pedals on the
crank arms.
Right
7KHOHIWSHGDOLVIXUWKHULGHQWLÀDEOHE\DJURRYHOHWWHURQWKH
pedal collar.
Left
Copyright Motobicycles 2012
Designed in Berlin
Engineered, produced and
assembled in Germany
©
Notes
Grip tape pads
Please stick the supplied
grip tape pads on the top and
bottom side of the pedals.
Please note that the pedals are not designed for competition use.
We recommend lubricating the bearings with BERULUB FR 16
or equivalent lightweight, silicone-free, synthetic special grease
with PTFE additives. Please note that the pedals need to be
GULYHQIRUWRNPEHIRUHWKHVOLGHEHDULQJVUHDFKWKHLUÀQDO
smoothness.
For information regarding pedal maintenance, please read the
maintenance manual, available on our website.
20120917_MOT_PEDAL_MANUAL_ENGLISH_NR21_FIN.indd 2 17.09.2012 18:43:40