Motorola Symbol CS3070 Operating and maintenance manual

P a g e | 1
Pairing your Motorola CS3070 Scanner to workSmart! iBreeze
iPad/iPhone/iPod Touch
Copyright Notice
© Copyright 2012 Mobile Workforce, Inc. All rights reserved.
Mobile Workforce, Inc. has copyright ownership of the Mobile Workforce-workSmart! applications and other software related materials. This
manual may not, in whole or in part, be copied, photocopied, reproduced, translated, or reduced to any electronic medium or machine-
readable form without prior consent, in writing, from Mobile Workforce, Inc. All Mobile Workforce, Inc. software is licensed in accordance with
the terms and conditions of the purchase, lease, or license agreement by which this software product was acquired. No ownership of Mobile
Workforce, Inc. software products is transferable. Law prohibits the use of this software beyond the terms of one or more of the
aforementioned agreements, without the written consent of Mobile Workforce, Inc. Microsoft, Windows, and Internet Explorer are either
registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries. WorkSmart!, workSmart!-Mobile,
workSmart!, are registered trademarks of Mobile Workforce, Inc.

P a g e | 2
Detailed instructions for pairing Motorola CS3000 with workSmart iBreeze on anApple
iPad/iPhone/iPod Touch
You will need:
Motorola Scanner
Bluetooth compatible iPad/iPhone/iPod Touch with workSmart! iBreeze
1. Press the scan button (+) to wake the scanner.
2. Press and hold the Bluetooth button (round button with Motorola logo) for five seconds. The scanner
beeps and the Bluetooth button starts blinking quickly to indicate that the scanner is discoverable by
the host.
3. On your Apple iPad/iPhone/iPod Touch, tap Settings, General, Bluetooth and slide Bluetooth from off
to on.
4. Your device number will show up on the Bluetooth keyboard, tap the device number and your
iPad/iPhone/iPod Touch will tell you to enter the PIN code. To enter the PIN code, scan the numeric
barcodes then scan enter on page 2. Your scanner should then beep and the blue led light will go from
blinking rapidly to blinking slowly.
5. Once the scanner is blinking slowly you can begin to use workSmart! iBreeze to scan your products.
Please note that scanning directly into workSmart! Web is not supported, you will need workSmart!
iBreeze installed on your iPad/iPhone.
6. If the scanner is not used for several minutes, it may go into sleep mode. Press the scan button (+) to
wake the scanner

P a g e | 3
Numeric Barcodes