4. DETECTOR PROCEDURE
4-1 RF detector operation
1) Connecting antenna( 3-5, Fig. 1 ) to the RF detector.
2) Turn on the RF detector by Turn the " rotary switch "
( 3-6, Fig. 1 ), the power led indicator will be light .
Turn off the RF detector by Turn the " rotary switch "
( 3-6, Fig. 1 ) to off position, the power red LED indicator
will be Extinguished .
3) When Turn on the RF detector system is start working now.
4-2 How to use the rotary switch adjust sensitivity
Turn the rotary switch to find the target device.
Turn the rotary switch right to maximum, go to standby mode,
if receiving stronger environmental then adjust the rotary
switch back, the light flash no more than the firth LED light.
when the indicator light 10 LED bar bright/flashing full,
means it is near to the target, we can change the detector
direction, and turn the rotary switch back when the signal
is strong, in this way, we can find the target easily.
NOTE :
the RF detector is wireless detector, for any emission
and receive device, so when use the product ,
Please turn off the known signal source nearby,example
Mobile phones, wireless sharing devices, radios,etc…
to ensure the accuracy of detection.
4-3 Buzzer ON/OFF
Press the Buzzer ON/OFF Button once to select Buzzer ON or
OFF ,when Buzzer sound select to ON and detector signal
more than the 6 led bar, the beep will be sound.
4
