MRC VP-17C User manual

VP-17C
PTFE Coated Chemical Resistant Vacuum Pump
PLEASE READ THIS MANUAL CAREFULLY BEFORE OPERATION
3, Hagavish st. Israel 58817 Tel: [phone], Fax: [phone] [email protected]
MRC.5.17

This instrument is designed for laboratory usage only. Please read this manual carefully before
installing or operating this equipment. The instrument shall not be modified in any way. Any
modification will void the warranty and may result in potential hazard. We are not responsible for
any injury or damage caused by any non-intended purposes and modifying the instrument without
authorization.
1. Check the voltage specified on the name-plate and ensure it matches the line voltage in
your location.
2. Do not suck into the aqueous, organic solvents or corrosive gases.
3. Install the instrument in a clean, dust-less and ventilated area under 40℃.
4. To avoid damaging the pump easily, please vent the pump before starting the pump.
5. This pump has a thermal protection device that automatically shuts-off when it becomes
overheated.
6. The temperature of the surface of pump is very high after use or during work, please don’t
touch it to avoid being burnt.
7. Do not use any lubricant, which may damage the pump.
8. Never spray flammable or toxic materials.
9. If the supply cord is damaged, Please contact the manufacturer or your service agent for
replacement to avoid hazard.
When unpacking, notice ifthe pump is in good situation. If not,please contact the distributor or
contact us by e-mail.
Unpacking
Important notice

Position Designation
1 On/Off switch
2 Air outlet
3 Air Inlet
4 Vacuum Gauge
5 Drain valve (Regulator)
6 Moisture trap
Main Part Diagram
1
2
4
3
5
6

Operating procedure
1. Press on/off (1) button to activate the pump after making sure all tubing are well connected.
2. To setup vacuum by adjusting the regulator (5).
* Warning: When pump is used for water filtration, please ensure the liquid level of flask not
exceed safety level. Failure to comply could result in serious damage to the pump and
void the warranty. If it occurs, please contact the distributor immediately for service.
1. If the moisture trap is full of liquid more than 70%, please stop doing the experiments
immediately and remove the liquid.
2. After finish the experiment, please remove the liquid in the moisture trap and pumping the
air for 1 minute to withdraw the residual steam.
189300-11VP-17C,PTFE Coated Chemical Resistant Vacuum Pump, AC110V, 60Hz
189300-22 VP-17C,PTFE Coated Chemical Resistant Vacuum Pump, AC220V, 50Hz
189301-06Moisture Trap / Vacuum Regulator
189300-62Repair kit for VP-17C
Ordering Information
Maintenance
Operation