MRC VP-68 User manual

MANUAL: VP-68
Oil-Free Vacuum Pump
PLEASE READ THIS MANUAL CAREFULLY BEFORE OPERATION
3, Hagavish st. Israel 58817 Tel: [phone], Fax: [phone] [email protected]
MRC.6.17

This instrument is designed for laboratory usage only. Please read this manual carefully before
installing or operating this equipment. The instrument shall not be modified in any way. ny
modification will void the warranty and may result in potential hazard. We are not responsible for
any injury or damage caused by any non-intended purposes and modifying the instrument without
authorization.
1. Check the voltage specified on the name-plate and ensure it matches the line voltage in
your location.
2. The pump is not corrosion-proof. Please do not operate it with corrosive gases or organic
solvent directly.
3. Install the instrument in a clean, dust-less and ventilated area under 40℃.
4. If you accidentally pump water in, please stop operating and contact your distributor for
service.
5. To avoid damaging the pump easily, please vent the pump before starting the pump.
6. This pump has a thermal protection device that automatically shuts-off when it becomes
overheated.
7. The temperature of the surface of pump is very high after use or during work, please don’t
touch it to avoid being burnt.
8. Do not use any lubricant, which may damage the pump.
9. Never spray flammable or toxic materials.
10. If the supply cord is damaged, Please contact the manufacturer or your service agent for
replacement to avoid hazard.
11. This appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning use of the appliance in a safe
way and understand the hazards involved.
12. Children should not play with the appliance. Cleaning and user maintenance shall not be
made by children without supervision.

13. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.

When unpacking, notice if the pump is in good situation. If not, please contact the distributor or
contact us by e-mail immediately for assistance: [email protected].
Position Designation
1 On/Off switch
2 Muffler ( ir outlet)
3 ir Inlet
4 Vacuum Gauge
5 filter cartridge
6 Moisture trap
7 Drain valve (Regulator)
Operating procedure
1. Press on/off button to activate the pump after making sure all tubing are well
connected.
2. To setup vacuum by adjusting the regulator .
* Warning: When pump is used for water filtration, please ensure the liquid level of flask
not exceed safety level. Failure to comply could result in serious damage to the pump
and void the warranty. If it occurs, please contact the distri utor immediately for service.

How to replace cartridge
1. Please replace the cartridge when it is saturated with moisture or particle.
2. Please remove the moisture trap by rotating it counterclockwise.
3. Replace the cartridge by the same way.
167801-11 VP-68 Vacuum pump, C110V/60Hz
167801-22 VP-68 Vacuum pump, C220V/50Hz
167801-62 Repair kit for VP-68
167600-42 Muffler ( ir outlet)