MTHTrains Premier 20-91219 User manual

M.T.H.
7020 Columbia Gateway Drive
Columbia, MD 21046-1532
LIMITED ONE YEAR WARRANTY
This item is warranted for one year from the date of purchase
against defects in material or workmanship. We will repair or
replace (at our option) the defective part without charge for parts
or labor, if the item is returned to the address below within one
year of the original date of purchase. This warranty does not
cover items that have been abused or damaged by careless
handling. Transportation costs incurred by the customer are not
covered under this warranty.
This warranty gives you specific legal rights and you may have
other rights which vary from state to state.
M.T.H. Electric Trains, Inc. • 7020 Columbia Gateway Drive • Columbia, MD 21046-1532
The Premier Steel Caboose offers a new level of
excitement and realism for your O Gauge
model railroad. Constructed from sturdy ABS
plastic, the Steel Caboose was created from
quality components and has been designed for
years of operation.
The Premier Steel Caboose comes fully
assembled, decorated and ready for use right
out of the box. The Steel Caboose features an
illuminated interior and exterior marker lights,
controlled from track power. Use and operation
is made easy by following the instructions on
the following pages.
ELECTRIC TRAINS, INC.
Caboose
Steel
Unplug the red LED's
from underneath the
interior.
There will be two spots of hot
glue holding the LEDs in
place. Use a screw driver to
loosen the wires from the
spots of glue. Pull the LEDs
back towards the inside of the
shell to remove them.
Replace the LEDs with a new
set and use hot glue to put
the wires back in place. Plug
the wires back into the
connector under the interior.
When reassembling, the end
posts of the shell must pass
through the corresponding
holes in the interior.
STEP
66
STEP
77Wires should be
tucked behind these
clips upon re-assembly
End posts
of the shell

INSTRUCTIONS To replace the interior light bulbs, follow these steps. 1) To remove the shell from the chassis, remove the four mounting
screws located underneath the trucks. 2) With the four screws removed, lower the chassis from the shell, take care not to
pull the wires out. 3) To be able to separate the interior from the shell you need to remove the step platform from both ends.
In order to do this you need to loosen the Ladder from the Catwalk. You must do this carefully so that you don't scratch the
paint on the roof of the caboose. First remove the ladder from the Catwalk by pulling the ladder upward and outward.
With the step platforms removed you can then lower the interior from the shell (to completely remove the body from the interior, go to Step 6 which is found
on the back page). 5) You can now replace the bulbs by pushing the socket up from the bulb holder and pull the bulb from its socket. Replace the middle bulb
simply by pulling it from its socket. Replace with a new one, and reverse the steps to reassemble the caboose. To replace the two red LED lights at the end
of the caboose follow steps 1- 4, above and below, and 6-7 on the back page.
You can then remove the step platforms.
4)
STEP
11
Remove these
four screws
STEP
22
STEP
33STEP
55
STEP
44
STEP
STEP
STEPSTEP
1
2
33
STEP
4STEP
5
Ladder
Step
Platform
Vertical Bulb