7
4.6
Convert File
(1)
Connect the USB in the power-on state, and the temperature value
display area will display the file type being converted. During file
conversion, the red indicator light flashes once every 1s. After the
conversion is completed, the green indicator light stays on, and the
screen prompts "uSb".
After unplugging the USB, if the file conversion is completed, the instrument
displays normally; if the file conversion is not completed, the instrument
flashes “Err” and returns to the measurement interface after flashing three
times.
(2)
When the USB is connected to convert the file in the power-off state, the
response mode of the instrument is the same as that in the startup state, but
after the USB is unplugged, the instrument remains in the power-off state.
Note: After the file conversion is completed, you can find the U disk in "My
Computer" and export the file to the computer. If not exported, the newly
converted file will overwrite the original file in the U disk.
4.7
Alarm
Description
The instrument does not have any alarm in the non-recording state. In the
recording state, the over-limit alarm prompt is as follows:
(1)
The data is normal, and the green indicator flashes every 10s.
(2)
When the data exceeds the limit in the power-on state, the screen
prompts “ ”, and the buzzer and red indicator light respond once every
0.5s. At this time, short press two buttons at the same time to turn off the
buzzer alarm.
Note: When the data returns to normal and exceeds the limit again,
the buzzer will automatically alarm.
(3)
When the data exceeds the limit in the power-off state, the buzzer does
not respond, and the red indicator light responds every 10s.
