SN8000 EVK User Guide
Page 3 of 30
THE TABLE OF CONTENTS
1. INTRODUCTION.................................................................................................................................6
1.1 ACRONYMS ..........................................................................................................................................6
1.2 REFERENCES ........................................................................................................................................6
2. SETTING UP THE SN8000 EVK FOR WINDOWS.........................................................................7
2.1 SN8000 SDIO ADAPTER ......................................................................................................................7
2.2 SN8000 EVB.......................................................................................................................................8
2.2.1 Programming and debug interface...............................................................................................9
2.2.2 UART interface ...........................................................................................................................9
2.2.3 Serial flash...................................................................................................................................9
2.2.4 EVB supply jumper setting........................................................................................................10
2.2.5 SN8000 supply jumper setting...................................................................................................10
2.2.6 Application button and LED......................................................................................................10
2.2.7 Header pads...............................................................................................................................10
2.3 USING THE PRELOAD FIRMWARE ........................................................................................................10
2.3.1 Wifi status..................................................................................................................................11
2.3.2 Wifi scan and join......................................................................................................................11
2.3.3 Wifi IP config............................................................................................................................13
2.4 SETTING UP THE WICED SDK...........................................................................................................13
2.4.1 Install the WICED SDK and IDE..............................................................................................13
2.4.2 Connect the SN8000 Evaluation Board.....................................................................................14
2.4.3 Verifying USB Driver Installations...........................................................................................15
2.4.4 Uninstalling the USB drivers.....................................................................................................15
3. USING THE WICED IDE..................................................................................................................17
3.1 START IDE AND APPLY THE PATCH ....................................................................................................17
3.2 CREATE THE SN8000 MAKE TARGET..................................................................................................19
3.3 BUILD AND DOWNLOAD THE APPLICATION.........................................................................................20
3.4 RUN THE APPLICATION .......................................................................................................................22
3.5 DEBUG THE APPLICATION...................................................................................................................23
APPENDIX. RESTORE THE PRE-LOAD FIRMWARE ......................................................................24
