Murphy LM500 User manual


00‐02‐0785
11‐02‐2011
Section15

1

Bubble Lens Assembly Instruction (LM500/LM500-TF)
WARNING:PerformallinstallationswiththepowersourceOFF.Besureenginehas
cooledandpressurehasbeenrelieved.FollowallsafetypracticestopreventSEVERE
BURNS.
1
RemoveLensfrompackingmaterial.
Inspectforcosmeticflaws,scratches,orfingerprintsonthebubblelens.
Cleanasnecessaryusingasoftclothwithverymilddetergent&water,orisopropylalcohol.
2 Insertlargecutoutofdialintothelenssidewithlargernotchatan
angleasshown.
3 Pressthesmallendofthedialcutoutinwithboththumbsuntil
fullyseated.

4 Carefullyplaceo‐ringaroundthelens. 



00‐02‐0785
11‐02‐2011
Section15

2

NOTE :ForadditionalinformationontheLM500(specificationsandinstallationinstructions),
searchLM500ontheFWMurphyWebsite( www.fwmurphy.com ).AttheLM500Webpage,
selectthe Literature tabandchoose InstallationInstructions .
5 Lineupboltholepattern,pushfromcenteroflens,andinstall
finger‐tightsix(6)shoulderbolts.(SeeStep6fortorque
instructions.)
6 Useatorquewrench/torquegunsetat12in‐lbstoattachthescrews.
Tightenscrewsusingacrosspattern.(12in‐lbsisapproximatelyequivalentto1/8turnafterthe
shoulderboltbottomsout.