My Child Walk 'n' Rock User manual

Walk ‘n’ Rock
2-in-1 Baby walker
V12
INSTRUCTIONS: Read the instructions carefully before use and
keep them for future reference. The child may be hurt if you
do not follow these instructions.
BS EN 1273:2005.
This baby walking frame is intended to be used by children who can sit
up unaided, approximately from 6 months. It is not intended for children
who can walk by themselves and weigh more than 12Kg/26.5lbs.

page 1
Safety instructions
Warning: Never leave the child unattended.
Warning: The child will be able to reach further and move rapidly when in the baby
walking frame:
• Prevent access to stairs, steps and uneven surfaces.
• Guard all res, heating and cooking appliances.
• Remove hot liquids, electrical exes and other potential hazards from reach.
• Prevent collisions with glass in doors, windows and furniture.
• Do not use the baby walking frame if any components are broken or missing.
• This baby walking frame should be used only for short periods of time (e.g. 20 min).
• This baby walking frame is intended to be used by children who can sit up
unaided, approximately from 6 months. It is not intended for children weighing
more than 12Kg/26.5lbs.
• Do not use replacement parts other than those approved by the manufacturer or
distributor as this may make the the walker unsafe and will invalidate the warranty.
• Never use the baby walking frame without the supplied Anti-fall blocks attached.
• Never use the baby walking frame without the supplied wheels attached.
Your 3 year warranty
Whilst we make and test our products to the highest standards of durability there’s
always a small chance of a hiccup! Our promise is to repair, replace or refund a
MyChild product that has an identied manufacturing defect from the date of
purchase for a full 3 years thereafter at no extra cost.
However, you must register within 28 days of the date of purchase to receive the full 3
years guarantee!
To receive your full guarantee you can register your product by:
visiting www.mychildonline.co.uk/warranty.html and complete the warranty form,
or by telephone on 0161 335 2508.

page 2
Battery disposal
Exhausted batteries should be removed from the product and taken to
a recycling facility. You can place batteries marked alkaline in normal
household waste, but these are better taken to a recycling facility.
Please follow these symbols on batteries, which contain harmful substances:
Pb = Battery contains Lead
Cd = Battery contains Cadmium
Hg = Battery contains Mercury
Batteries should not be considered
regular waste. Empty batteries
should be returned to a recycling
facility
Cd HgPb
Battery warnings
Always take care to insert your batteries correctly, observing the plus and minus marks
on the battery and appliance.
Do not mix new and used batteries.
Do not mix different types of batteries.
Always remove dead batteries and all batteries if you are not going to use the product
for long periods (as batteries may leak and cause damage).
Exhausted batteries should be removed from the product and disposed of in
accordance with the makers recommendations.
Only place batteries marked alkaline in normal household waste.
Never attempt to re-charge ordinary (non-rechargeable) batteries.
Batteries should always be changed by an adult.
Keep batteries out of reach of children.
Never dispose of batteries in a re this may cause them to explode.
Children can choke on batteries. If swallowed seek medical advise immediately.

page 3
Parts checklist
Welcome
Thank you for purchasing the MyChild Walk ‘n’ Rock 2-in-1 Walker.
Please read the instructions and warnings carefully before use to ensure safe and
satisfactory operation of this product.
Your child’s safety is your responsibility. If you have a query with this product or require
replacement parts, please contact the MyChild Helpline on 0161 335 2508.
Lay out the parts on a soft level surface and compare to the part/xings checklist
below. Do not discard any packaging until you are sure that you have all the parts.
WARNING! Assembly by an adult. Keep away from children until fully assembled. Keep
children clear during assembly as pack contains small parts which may present a
choking hazard.
Contained in your carton are:
NoPart Qty
1 Walker body 1
2 Seat unit 1
3 Musical play tray* 1
4 Footrest pad 1
5 Front wheels 2
6 Rear wheels 2
7 Wheel pusher 1
8 Anti-fall blocks 8
9 Flexi toys* 2
10 Toy rings 3
*Actual style may vary
You will require one Phillips screwdriver
(not supplied).
1
3
5
910
6 7 8
4
2

page 4
Opening and closing the baby walker
Attaching the walker’s front wheels
BC
A
1. To open, or raise the height, ensure
that block (A), as shown in step 2 is in the
unlocked position (B), hold either side
of the upper part of the walker and pull
upwards until you hear a click. When at
the desired height turn the lock to the
locked position (C).
2. To close or lower the height, rst ensure
block (A) is unlocked (B) then pull block
(A) forward and lower the walker. When
at the desired height turn the lock to the
locked position (C).
WARNING! NEVER adjust the height when your child is in the walker. DO NOT place your
child in until you have adjusted the height and locked the height adjust lock.
3. With the baby walker upside down
and fully folded down, insert the two front
wheels into each round hole on either
corner at the front of the walker.
Tip: Use the provided wheel pusher tool
to press the wheels in (tap the back of
the wheel pusher lightly with a hammer if
required)

page 5
Attaching the walker’s rear wheels
Attaching the walker’s anti-fall blocks
The footpad
4. Insert the two rear wheels into each
round hole on either corner at the rear
of the walker, ensuring the small plastic
block (A) is seated in its hole.
Tip: Use the provided wheel pusher tool
to press the wheels in (tap the back of
the wheel pusher lightly with a hammer if
required)
A
5. With the baby walker still upside down
and fully folded down, place the anti-
fall blocks around the walker as shown,
inserting the two plastic stems on each
block into the holes on the walker’s
underside.
ATTENTION! Ensure the narrow end of
each block points to the corner of the
walker.
DO NOT USE THE WALKER WITHOUT THE
ANTI-FALL BLOCKS ATTACHED
6. The footpad must be tted in the rocker
mode, and when you don’t want your
child to move about in the walker mode.
Attach using the six clips on the footpad
and hook over the side bars on either side
of the base.

page 6
Fitting the seat unit
8. Attach all plastic connectors on
the seat unit to the walker body in the
following order:
A. Starting with the seat unit’s arm rest
insert pins into keyhole slots (A1) and (A2),
by pushing the pin into the larger end of
the keyhole, then slide the shaft of the
pin into the smaller end of keyhole until it
clicks in place (see Fig 1).
B. Then attach the seat units back rest by
pushing the plastic clips (B1), (B2), (B3)
and (B4) into the holes. Start from one
side and work your way around. Grip the
back of the seat unit as low down and
close to the plastic clip as possible (see
Fig 2) and ensuring the clip is lined up with
it’s hole, push the clip in.
If a clip is not protruding from the seat
unit you may need to locate it and pull it
through the hole in the seat cover.
C. Finally insert the pins at the front of the
seat unit into keyhole slots (C1), (C2) and
(C3). (see Fig 3)
Warning: ensure all pins and clips are
properly attached before placing your
child in the seat.
7. Lower the walker all the way down,
place the walker on a at level surface
then place the seat unit in to the centre
of the baby walker.
A1 C1 C2 C3
B1
B2 B3
B4
A2
Fig 1
Fig 3
Fig 2

page 7
Attaching the exi-toys
Using walker and rocker modes
WARNING: Assembly by an adult.
9. Add three of the toy rings to one exi-
toy and slot the exi-toys into the holes
provided on either side of the main body
of the walker.
Note: The exi-toys shown may vary from
those included with the product.
10. Grip the sliding blocks at the front of
the walker on the walker base and move
them in opposite directions as shown.
11. Separate the blocks and repeat the
procedure on the rear of the walker.
LOCK
OPEN LOCK
OPEN

page 8
Using walker and rocker modes (continued)
Musical play tray
12. Press the buttons (A) at each end of the walker base and and at the same time
turn the base upward 90 degrees until it clicks into place. Repeat the process on the
opposite side.
To convert the rocker back to a walker, simply reverse the steps 10 to 12.
Press in buttons (A), turn base back down, close the end blocks together and
reconnect.
WARNING! DO NOT convert from rocker to walker or vice-versa whilst your child is
seated in the walker.
AA
13. Using a Phillips screwdriver, unscrew
the battery cover on the underside of the
musical play tray.
Insert 2 x 1.5V AA batteries (not supplied)
ensuring the correct battery orientation is
observed and then reattach the cover,
replacing the screw, making certain it is not
overtightened.

page 9
Musical play tray (continued)
15. On the underside of the musical play
tray you will nd a holding strap which
can be used to attach the toy to your
child’s cot or pushchair. Wrap the strap
around something suitable and insert tab
(A) into keyhole slot (B).
To attach to the walker use suckers (C)
and place in the recess on the front of
the walker.
A
B
C
Top Tip:
14. Some brands of batteries will have
slightly different lengths than others.
If you nd the musical play tray is not
working with fresh batteries then this may
be because the positive terminal is not
making proper contact. To rectify this,
rst re-insert the batteries if this does not
work, try a different brand. Finally if the
play tray still fails to work, please contact
MyChild customer service.
+

page 10
Care and maintenance
• To prolong the life of your nursery product keep it clean and do not leave it in
direct sunlight for extended periods of time.
• Removable fabric covers and trims may be cleaned using warm water with a
household soap or a mild detergent. Allow it to dry fully, preferably away from
direct sunlight.
• If the wheels squeak - use a silicon based spray ensuring it penetrates the wheel
and axle assembly.
• Do not dry clean, or use bleach.
• Do not machine wash, tumble or spin dry, unless the care labelling on the product
permits these methods.
• Non removable fabric covers and trims may be cleaned using a damp sponge
with soap or mild detergent. Allow it to dry completely before folding or storing it
away.
• In some climates the covers and trims may be affected by mould and mildew. To
help prevent this occurring, do not fold or store the product if it is damp or wet.
Always store the product in a well ventilated area.
• Always check parts regularly for tightness of screws, nuts and other fasteners -
tighten if required. To maintain the safety of your nursery product, seek prompt
repairs for bent, torn, worn or broken parts.

[email protected]
Imported by MyChild. M34 3QA
www.mychildonline.co.uk
Tel: [phone]