My Green Mattress My Green Platform Bed Twin User manual

Assembly Instructions
My Green Platform Bed
Twin
Align one end board, one right leg, and one left leg
so that pockets are all facing the same direction.
Fit the dowel pins on the end board into the pre-
drilled holes on the legs.
Insert one wood screw into each of the four pocket
holes on the end board.
Use a Phillips-head screwdriver to tighten each
wood screw.
Repeat above steps using the opposite end board,
right leg and left leg.
Step 1.Attach legs to end boards Dowel pins
Pocket holes for wood screws
Locate an outside rail.
Position the rail such that the notches are on top and facing
in toward the middle of the bed frame.
Insert one end of the rail into the notch on one of the legs.
Insert a barrel nut into each of the two pre-drilled holes on
the rail.
Insert a panhead screw into each of the two predrilled holes
on the leg. Be sure screws go through the barrel nuts in the
rail. Tighten the panhead screws by hand for now.
Insert the opposite end of the rail into the notch on the
opposite leg.
Insert a barrel nut into each of the two pre-drilled holes on
the rail.
Insert a panhead screw into each of the two predrilled holes
on the leg. Be sure screws go through the barrel nuts in the
rail. Tighten the panhead screws by hand for now.
Repeat all steps above to attach the second outside rail.
Ensure that the notches in the second outside rail are on top
and facing toward the middle of the bed frame.
Step 2. Attach two outside rails
Panhead screw (12)
Barrel nut (12)
Hex-key allen wrench (1)
Hardware Included
Hardware Not Included
Phillips-head screwdriver
Wood screw (8)
Left leg (2) Right leg (2)
Slat with pre-drilled holes (2) Slat without holes (13)
Parts Included
End board (2)
Dowel pins
(pre-installed)
Watch our instructional video on our website:
mygreenmattress.com/product/my-green-platform-bed/
Outside board (2)

Locate a slat that has predrilled holes.
Locate a set of notches on the rails that have predrilled holes.
Lay the slat into the notches.
On one end of the slat, insert a barrel nut into the pre-drilled
hole. Do the same on the other end of the slat.
On one of the outside rails, insert a panhead screw into the pre-
drilled hole. Be sure the screw goes through the barrel nut in
the slat. Tighten the panhead screw by hand for now. Repeat
this step on the other outside rail.
Repeat all steps above to attach the other slat that has pre-
drilled holes.
Step 3.Attach the two slats with pre-drilled holes
Attach the remaining slats by inserting them into the
remaining notches on the rails.
No hardware needed.
Step 4.Attach the remaining slats
After all parts of the platform bed are assembled, use the included
hex-key allen wrench to tighten all of the panhead screws.
Re-tighten the panhead screws every six weeks to ensure the bed
remains sturdy.
Step 5. Tighten all panhead screws