
2. Technical Parameters
Power: 110v or 220v
3. Precautions on Use
(1) A plug with a ground pin must be used, and a power socket that is already
grounded must be ensured before using the equipment.
(2) Make sure the voltage of the equipment is adaptive. If the local power supply
voltage is not stable, we suggest users add a voltage regulator with matching
power between the mains supply and the equipment.
(3) Please uniformly use specified parts provided or suggested by the original
manufacturer to guarantee the equipment's curative effect and normal service
life.
(4) The equipment can't be placed in damp places or near water, and it also can not
be exposed to direct sunlight.
(5) Please don't place the equipment near an intense heat source since this may
affect its service life and everyday use.
(6) Please remove all the metal objects from the body before use to avoid
unexpected situations which may affect the curative effect.
(7) Please refrain from using the equipment to aim at eyes, thyroid, parathyroid,
testicles, pregnant woman's abdomen, pacemaker, etc.
(8) Those suffering from an illness should use it with caution unless they get
permission from a doctor.
(9) Please turn off the equipment's power switch if no one uses it, and ensure the
main power is off after everything is settled. Thus, the safety of the equipment
can be guaranteed.
(10) When operating the device, start from the lowest RPM and gradually increase it
after the client gets used to it.
(11) The handpieces can be used separately, but a better effect can be achieved with
the combined use.
(12) It's advised to stop taking other weight-loss medicines for 1 to 2 months before
treatment if you are taking them now. The course of treatment shall be extended
if you want to take it immediately.
(13) Women in pregnancy or menstruation and infants are forbidden to use the
equipment; a child should use it under the guidance of an adult.
(14) After the operation, clean the equipment with normal saline to ensure its
cleanliness and hygiene and extend its service life.
4. Common Problems & Solutions
(1) Does the equipment can't be started, and the buttons on it can't light up?
A. Make sure the power cord is plugged into a good power socket.
B. Check whether the fuse tube in the back is loose or burnt out.