MYERS Bee Cosy 1450 Installation guide

Do Not’s
To care for your new bed in the correct way and ensure you
do not invalidate the guarantee, please be aware of
the following:
Do not bend or fold the mattress
This is likely to damage the spring unit and will invalidate
the guarantee.
Do not overload drawers
The weight of items stored in the drawer must not exceed
7kg, and should be spread evenly. Excessive weight or over
lling the drawers can restrict movement or damage the
drawer.
Do not use chemical or detergent cleaners
Should the mattress get dirty, rub lightly with a sponge using
a weak solution of soap and water. We do not recommend
using chemicals or detergent as this may damage the mattress
fabric and llings.
Do not use the headboard
to move the entire bed
Do not remove the re label
Do not sit on the edge of the bed
for prolonged periods
Do not kneel or stand on the bed
Guarantees
5 Year Guarantee
For your peace of mind, Myer’s oer a 5 year guarantee on
mattresses and divans, and a 1 year warranty on headboards.
In the unlikely event that a manufacturing fault develops
during the guarantee period, please contact the retailer
where you made your purchase with the nature of your
complaint. To assist the retailer you will need to provide the
following information:
•Date of purchase
•Sales order number or receipt of purchase
•Product name and size
•Full description of complaint
The following conditions apply to the guarantee:
•Claims made under this guarantee must be submitted in writing to
the retailer where the original purchase was made
•All claims must be supported with proof of purchase; original receipt
or invoice
•The guarantee will become invalid if:
a. the product is found to have been mistreated, damaged or the
product has not been maintained in accordance with the care
instructions supplied. This includes the mattress being turned
or rotated on a regular basis, if applicable.
b. the mattress under guarantee has been used with a damaged
divan or a divan that is deemed to be of unsuitable quality.
c. the mattress has been used on a slatted base with slats more
than 7cm apart.
•Myer’s reserves the right to substitute alternative materials if the
original is no longer available.
•In the event of a dispute Myer’s reserves the right to inspect the
product via a third party organisation such as FIRA (Furniture
Industry Research Association).
•Following a replacement or repair, the guarantee will remain valid
from the date of original purchase.
•This guarantee is not transferable
•The terms of this guarantee are governed under English Law
This guarantee does not aect your statutory rights.
Care instructions
Please read these instructions before using your new bed
Dec 2019

Installation
Tools required
Slotted Screwdriver Mallet
Pliers Scissors
To avoid the risk of injury it is recommended that 2 people
put the bed together.
Packaging disposal
Remove all polythene protective packaging and dispose of
carefully to avoid any possible injury to children. Please remove
any loose staples carefully with pliers and dispose of safely.
Airing a new mattress
Once you have removed your mattress from its packaging,
allow the mattress to breathe in a ventilated room for four
hours.
Mattress size
During storage and transit the mattress could become
compressed, once opened the mattress should go back to its
correct size within a couple of weeks.
Myer’s luxury mattresses are made to metric sizes, please refer
to the National Bed Federation website for information about
sizes and tolerances. www.bedfed.org.uk
Castors/Legs
Attach castors by pushing them rmly into position by hand
and give them a sharp tap with a mallet. Do not use a metal
object as this may damage the castor or base. Legs need to
be screwed in and checked regularly for tightness. The feet
and headboard bolts can be found either in the drawer or
attached to the underside of the divan base.
Connecting bases
Connect the two halves of double divan bases using the plastic
linking clips situated on the inside of the bases. The plastic clips
can become slightly compressed during transit so you may
need to carefully open the plastic clips by hand.
Attaching headboard
The headboard may be attached to either end of the divan
base. To t the headboard to the divan, you will need to
pierce the divan fabric with scissors to accommodate the
headboard bolts. The approximate location of this is marked
on the divan. Screw tight to secure the headboard in place and
check regularly for tightness.
Using a suitable base
We recommend that a Myer’s luxury mattress should be
used with a Myer’ s divan base, however if you wish to use
the mattress on another base, you should always be sure that
the base is t for purpose, otherwise it could damage your
mattress, which in turn would make your mattress guarantee
invalid. If you are using with a slatted base, the spacing
between the slats should be no more than 7cm.
We recommend that any bedframes with slat gaps bigger
than 7cm should be tted with pegboard sheeting between
the slat base and the underside of the mattress to maintain
our guarantee support. Do not use your mattress on solid
plywood or hardwood as this would restrict ventilation and
cause deterioration on the underside of the mattress.
Caring for your bed
Getting used to your bed
Your new bed may feel a little strange at rst and dierent
from what you are used to sleeping on. Don’t worry, you just
need to give it some time to adjust and for the llings in the
mattress to settle.
Turning your mattress
Myer’s mattresses use generous layers of the nest
upholstery materials which may take longer than inferior
quality beds to settle evenly. The settlement will rst be
evident in the most common sleeping positions; this is
quite normal and should not concern you. Turning or rotating
your mattress is the equivalent of plumping up your cushions.
Mattresses should be turned over or rotated every two weeks
for the rst six months and at monthly intervals thereafter.
Cleaning your mattress
Dust can be removed from your mattress using a soft brush,
we do not recommend using a vacuum as this will disturb the
mattress llings.
Discolouration
The chemicals used for re retardancy may sometimes react
with other chemicals such as deodorants and perspiration,
causing discolouration. This is completely harmless and will
not aect the performance of the mattress.
Protecting your mattress
We recommend the use of a mattress protector to help
prolong the life of your mattress.
Airing your mattress
We recommend you leave your bed to air for 20 minutes
every morning to allow body moisture to evaporate.