Mylaps X2 Club User manual

MYLAPS X2 Decoder - Quick start guide
Installing the MYLAPS X2 Decoder
The detection loop: Connect here the coax cable coming from the
detection loop to the MYLAPS X2 decoder.
The auxiliary port: This port can be used to connect a photocell,
external start pulse or a sync pulse. For more information on how
to connect these devices, see appendix D of the MYLAPS X2 decoder
manual.
The GPS antenna: Connect the GPS antenna cable and place the
antenna where it has a clear view of the sky overhead to be able to
make connections to satellites in order to synchronize to the time of
day very accurately.
CAN connector: for future use
The network: Use a UTP cable to connect the MYLAPS X2 Decoder to the
MYLAPS X2 Server on the red port of the MYLAPS X2 Decoder. The LEDs
on the connector will show if a physical network connection is available.
Power: Connect the supplied VDC adapter to the decoder and mains.
It is recommended to connect the VDC adapter to mains through
an Uninterruptable Power Supply (UPS) to avoid any interruption of
power supply to the decoder.
Technical Specications of the MYLAPS X2 Decoder
Dimensions 220x180x60mm / 8.7x7x2.4inch•
Weight 1.5kg / 3.3lb•
Clock Stability 0.5PPM•
GPSReceiver    quickx,-160dB,15nS•
GPS antenna connection SMA, active•
Timing Resolution 0,001s•
Loopconnection   1xBNC,max.20mloop•
Operatingtemperaturerange  -20to50°C/-4to122°F•
Humidity range 10% to 90% relative•
Operating voltage range 10 to 14.4VDC, Typical 12VDC•
Power consumption Appr. 5W•
NetworkInterface   10-100BT(RJ45)•
Auxiliaryconnector   DB15,Female•
Can connection Future use•
Specicationsaresubjecttochangewithoutnotice
12

CE information:
This device complies with the EMC directive 89/336/EEC. A copy of the declaration of
conformity can be obtained at:
MYLAPS Sports Timing
Zuiderhoutlaan 4
2012PJHaarlem
The Netherlands
FCC information:
Thisequipmentcomplieswithpart15oftheFCCrules.Operationissubjecttothe
following two conditions: (1) This equipment may not cause harmful interference, and
(2) this equipment must accept any interference received, including interference that
may cause undesired operation.
MYLAPS Ofces:
MYLAPS EMEA Ofce MYLAPS Americas Ofce
Haarlem Atlanta
The Netherlands USA
Tel: [phone] Tel: [phone]
E-mail:[email protected]  E-mail:[email protected]
MYLAPS Japan Ofce MYLAPS Asia Pacic Ofce
Tokyo Sydney
Japan  Australia
Tel: [phone] Tel: [phone]
Email: [email protected] Email: info.asia.paci[email protected]
MYLAPS Asia Ofce
Kuala Lumpur
Malaysia
Tel: [phone]
Email: [email protected]
mylaps.com
All rights reserved
Copyright©2011-2014MYLAPS
This publication has been written with great care. However, the manufacturer cannot
be held responsible, either for any errors occurring in this publication or for their
consequences.
The sale of products, services of goods governed under this publication are covered
by MYLAPS’s standard Terms and Conditions of Sales and this product publication
is provided solely for informational purposes. This publication is to be used for the
standardmodeloftheproductofthetypegivenontherstpage.
MYLAPSX2DecoderQuickStartingGuide/2014-06 4
3