Mynew Portable Car Umbrella User manual

Remote control automatic item
Automatic Car Umbrella
Shenzhen Mynew Technology Co.,Ltd
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
ЬReorient or relocate the receiving antenna.
ЬIncrease the separation between the equipment and receiver.
ЬConnect the equipment into an outlet on a circuit different from that to which the receiver is connected.
ЬConsult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modi㸚cations to this device not explicitly approved by manufacturer could void your
authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This
device and its antenna must not be located or operating in conjunction with any other antenna or transmitter.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable
exposure condition without restriction.
*Please read this manual carefully before using and safe keep the manual
1.Package details
Remote control automatic item:
Car Umbrella holder x1, Tarp x1, wireless remote controller x1,
car charger x1, Storage bag with zipper x1,
user manual and warranty card x1 .

2.Product diagram
ķCar umbrella handle ĸSuctionholder ĹAnti-thief safety rope
ĺWindproofhook ĻSoft rubber mat ļWindproof snap fastener
ĽReset ľCar charger socket ĿCar charger LED light
3.Installation steps
Unfold the car umbrella
1 . Open the trunk, take out the car umbrella from the trunk with your
hand on the handle, then close the trunk.
2. Put the car umbrella on the middle of the car sun roof, and with the
handle facing you.
3. Untie the gathering rope.
4. Take down the handle to fasten the car umbrella on the roof of the car.
5. Clip the anti-thief rope into the car .
6. Take out the remote controller, press bottom “B” to turn on the car umbrella till it fully
unfolded, then clasp the windproof hook ( Please adjust the rope to the proper length when use
it for the first time ), installation completed.
Unfold the car umbrella
1 . Take off the windproof hook, press “A” on the remote, till it well gathering.
2. Take out anti-thief rope from door of the car, then push up the handle to take off the car
umbrella, and put it into the trunk.

AC Charger : Please use the car charger which provided by the
factory to do the charging; the LED light turn red when the power
is insufficient, the LED light turn blue when the power is sufficient.
Remote Controller Instruction : Press the bottom"B"on the wireless remote control,
to open the car umbrella;Press the bottom"A" on the wireless remote control, to
close the car umbrella.
4.Product specifications
Remote control Automatic specification:
Product Name
Portable Car Umbrella
Unfold size
4000*2100mm
Fold size
220*220*850mm
N.W.
6KG
Color
Dark blue, Camo, Silver
Engine information
Engine
8 slot brushed Engine
Power
10W
Current
1A
Max current
3.5A
Max power
900N
Battery
Type of battery
Build-in Rechargeable Lithium Battery
Voltage
12V
Capacity
2200mah*3
Standard input
1A
Standard output
3A

5.Attention
1ǃPlease don't drive when using car umbrella!
2ǃPlease hook up the windproof hook after install the car umbrella!
3ǃNo using when heavy rain or heavy wind!
4ǃWhen there is heavy wind weather please fold the car umbrella urgently , keep all snaps untie
the tarp,then unlock the wind hook in case of being blown over.
5ǃIf the car umbrella remote control goes wrong, press the Āresetābottom to fold , otherwise
please connect the car charger to see if the power is not sufficient, if itÿs still not working, please
take off the lockpin, and fold umbrella manually. (As the picture shows below)
6ǃFor remote control automatic car umbrella, on the conditions that remote controller is missing,
or car umbrella run out of battery, please manually fold it and then contact with the afterservice
agent for a new remote controller.
Warranty
Warranty principles:
All our Car umbrella offer one year warranty since the purchase date, if the product is inhuman
damage problems, consumers can send back the car umbrella to after service station for repair
free of charge.
The product is out of warranty if one of below conditions happened:
gProduct goes wrong or broken, because user do not follow the user manual to install, use,
maintain or take care of the product.
gThe warranty time is invalid.
gUsers change any reset of the product or take apart the product without official permission.
gCar umbrella goes wrong or broken because of the accident or man-made , such as import the

improper voltage, high temperature, water damage, mechanical disruption, drop and break,
product oxidation, or rusted.
gThe product damaged because of the transportation or loading during send back for repair.
gThe product run wrong or damaged because of the force majeure such as Typhoon,earthquake,
fire, flood, thunder strike etc.
FCC Warnning:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void
your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement. The device can be used in
portable exposure condition without restriction.