NAD C 338 User manual

IMPORTANT! Follow these installation steps to add Chromecast casting capability to your C 338 amplifier.
C 338
Chromecast Built-In
7
Device has
been found
Open the Google Home app.
Tap Devices in the top right
corner of the screen
6
Your NAD C 338 is now in
hotspot mode and ready for
Wi-Fi setup
5
Light
Indicator
Press the front panel standby
button and wait for the power
indicator light to be a steady
pulsing blue
4
Set the POWER switch to ON at
the rear panel of the amplifier
2
Plug in the NAD C 338 and
connect each supplied antenna
to their corresponding
terminals on the rear panel
3
Connect a pair of speakers to the
amplifier’s corresponding right/left speaker
terminals. Double-check the speakers
before powering on the amplifier
1
Install the Google
Home app on your
mobile device
(If not already installed)
CONTINUE
9
Tap Continue once your
mobile device has
successfully connected
to the amplifier in the
Google Home app
8
Select the NAD Chromecast
built-in amplifier listed and tap
Set Up Continue Your mobile device will now
connect to your NAD amplifier
NADAmplifierDF432A
Needs Setup
Devices
IGNORE SETUP
PG 1

PG 2
16
Chromecast
Cast Button
You are now ready. Go to a music
streaming app or a song stored on your
mobile device and look for the cast icon to
start streaming music to your C 338
15
Tap Continue once the NAD
amplifier is connected to your
Wi-Fi network
NADLAB
NOTE
If an update is required for
your NAD amplifier, it will
automatically update at this
time and re-boot the amplifier
when the update is complete.
Follow these steps again after
the amplifier has re-booted
and the power indicator light is
pulsing blue.
14
NADLAB
Your NAD amplifier will now
attempt to connect to the provided
Wi-Fi network
Select the Wi-Fi network you want to
connect to your NAD amplifier
Android–Tap OK to automatically
fetch the password for this network
on your mobile device
13
DefaultWiFi
Get Wi-Fi password from this mobile
device?
Connect Chromecast built-in amplifier
to your Wi-Fi
Get Wi-Fi password from this mobile
device?
DefaultWiFi
Connect Chromecast built-in amplifier
to your Wi-Fi
Secured with WPA
NADLAB
Secured with WPA
NancyDrew
Secured with WPA
Enter the custom name of your NAD
amplifier using your mobile device
12
NADAmplifierDF432A
For example: “Bedroom Speakers”
Name your Chromecast built-in amplifier
Tap I Heard It once you
hear the sound play
through your speakers.
If not, tap Try Again
11
I HEARD IT
Adjust the volume of your
amplifier to a low but audible
level and tap Play Test Sound
10
PLAY TEST SOUND
C 338
Chromecast Built-In
Please contact support.nadelectronics.com for more information.
NAD Electronics International reserves the right to change specifications or features without notice. NAD is a registered
trademark of NAD Electronics International. All rights reserved. No part of this publication may be reproduced, stored, or
transmitted in any form whatsoever without the written permission of NAD Electronics International.
© 02/17 17-018 NAD Electronics International. www.NADelectronics.com