1
WARNINGS
GENERAL
Do not set and drive this model being vibrated.
Do not set and drive at hi‑temperature, hi‑density, and direct sun‑shine place.
Do not set and drive at metal‑dust, chemical‑liquid place.
Do not set and drive at the hi‑shock, hi‑vibration and hi‑magnetic places.
Do not take power from same source of hi‑noise as air‑conditioner’s.
POWER
Single power line only, to escape from noise troubles.
Turn OFF power switch without fail, while IN/OUT of plug.
Never handle power‑cord by wet‑hands.
PAPER
Do not stock paper at hi‑density, hi‑dry places.
Deformed or damaged paper causes printing troubles.
In case of NO PAPER, it warns blinking FEED SWITCH lump.
New paper can be set again even in printing, it will restart again after confirming new paper set.
Never OFF the power while setting new.
MECHANISM
Mechanism is mainly composed of gilt‑metal, which sometimes causes rust on the surface.
Be careful not to be influenced by magnet to lead‑switch as reset‑detector.
PRINTING HEAD
Do not print without paper. It will damage head and platen.
Do not touch head mechanism while printing.
Do not touch hot head mechanism.
Do not OFF the power while printing.
SHOCK
Do not drop or give any shocks to printer.
Do not give any materials, as water, liquid, pin, clip and metals in printer, which
will cause any troubles.
In case of any materials in it, turn OFF the power, and contact to dealer you bought this model.
Clean this model by wet and soft cloth.
Do not clean with THINNER and so, which will damage the casing, etc.
In case of troubles, turn OFF the power, then contact to dealer you bought.
MISCELANEOUS
Do not reprint this manual without permission.
The sentence, specifications and contents are subject to change without notice.
NADA guarantee this model against defects in material and workmanship. This
guarantee is void if the product has been altered, misused, taken apart or otherwise abused.
