Napier 13100 User manual

If you are missing parts, do not return to the store.
Model #13100
PACKAGE COMPONENTS
Tent Bag
Tent
Tent Tie Straps (2)
flyniaR
Pole Bag
)2(seloPtneT
Rain fly Pole (1)
Stake
Stakes (13)
Guide Ropes (4)
Instructions
WARNING
!
Keep all flame and heat sources away from the tent fabric. The tent is made with flame-resistant fabric which
meets CPAI-84 specifications. It is not fireproof. The fabric will burn if left in continuous contact with any flame
source. The application of any foreign substance to the tent fabric may render the flame-resistant properties
ineffective.
To prevent carbon monoxide from entering the vehicle and tent area, do not run the engine, do not cook inside
the tent, and do not use a gas heater in the tent. Carbon monoxide is dangerous to your health.
Engine must be off and exhaust must be fully cooled before tent installation and use.
SUV Tent
Bag

CAUTION
•Never smoke inside the tent. Never use candles, light
matches or allow any type of open flame in or near the
tent.
•Do not cook inside the tent.
•Do not store flammable liquids inside the tent.
•Allow adequate ventilation inside the tent at all times.
Never refuel lanterns, heaters or stoves inside the tent.
Leaving the tailgate open for an extended amount of
time will drain the battery of your vehicle. To avoid this,
ensure your interior lights are turned off
NEVER run the engine when the tent is attached to the
vehicle.
•
•
- Select a smooth level campsite clear of rock, branches
and other hard or sharp objects.
- Park the vehicle into the chosen campsite with the vehicle
in park and turned off. Apply the parking brake.
SETTING UP THE TENT
SELECT CAMPSITE
1) Remove the tent from the tent bag and lay it flat on the
ground with the vehicle sleeve facing the cargo area of
the vehicle. At this point, do not stake the tent to the
ground.
2) Assemble all poles by unfolding each section. You will
have 2 long tent poles and one short rain fly pole.
3) Slide one tent pole diagonally, corner to corner going
through the 2 pole sleeves in the roof of the tent. Repeat
with the other tent pole.
4) Take any pole end and insert the pin located on the
corner of the tent into the pole end. On the opposite
end of the pole, insert the pin into the end of the pole.
Repeat these steps for the remaining pole.
NOTE: The poles may get stuck on the pole sleeves. Do
not force the pole, simply go to the sleeve and lead the
pole through it.
5) Once the tent is standing, attach the plastic clips to
the tent poles.
•

ATTACHING TO YOUR VEHICLE
C) Ensure the exhaust pipe is outside the sleeve.
WARNING: Carbon Monoxide gas is dangerous
and can cause unconsciousness or death. Never
start or run the vehicle’s engine when the tent
is attached to the vehicle.
6) From inside the tent, unzip the door and mesh that
faces the vehicle to access the cargo area. Roll up
mesh and secure with the T-straps.
A) Move the tent towards the cargo area of the vehicle.
Slip the sleeve under the bumper and over the roof.
B) Hook the bottom outside strap to any part of the wheel
well and tighten the strap. Repeat on opposite side.
7) Attaching the vehicle roof straps.
A) WITH A ROOF RACK, remove the long strap from the
female clip. Attach the 2 short straps around the
roof rack. Repeat on the opposite side and tighten
straps to secure tent.
B) WITHOUT A ROOF RACK, extend the long straps to
the front of the vehicle. Open the vehicle hood and
attach the hooks to the hood hinge or frame.
Tighten the straps to secure the tent.
8) From inside the tent, attach the center hook to the
tailgate latch.

WARRANTY INFORMATION
11)
Setting up the Rain fly and Awning
TENT CARE TIPS
Napier Tents have a one (1) year warranty period from the time
of purchase against defects in improper workmanship. Normal
wear and tear, seam leakage through needle holes and improper
use, abuse or alteration are not covered under the warranty
policy. Napier will replace or repair defective parts. Replacement
parts may be new or re-built at Napier Outdoors sole discretion.
In order for the warranty to be valid, you must provide a proof of
purchase (receipt) to prove the date of purchase. If you do not
provide the proof of purchase or are after the warranty period,
replacement parts can be purchased.
1) We highly recommend seam sealing your tent prior to
camping as water may penetrate the needle holes in the
fabric. This is common with tents and is not a defect.
2) Condensation will form on the inside surface of your tent.
It is caused by water vapor from your breath, perspiration
or any wet items inside the tent. Water on the inside of
the tent is NOT leakage through the tent fabric. To reduce
leave door and windows partially open.
3) The water resistant coating may wear down over time.
It is sugguested to spray a water resistant coating onto
the tent and rain fly ever few years.
4) Avoid spraying insect repellent, hair spray, etc., inside or
near your tent, as they may be harmful to the tent fabric
and cause leakage.
5) Do not leave your tent set up in direct sunlight longer
than necessary. If left in sunlight for prolonged periods of
time, fabric will fade and weaken.
6) If zippers stick, lubricate with silicon. Never force a zipper
as this will bend and prevent the zipper from closing.
Continual use in a sandy environment can cause a slider
to erode and fail to close.
7) NEVER roll up or pack away a wet/damp tent. This will
cause mildew. Make sure your tent is completely dry
before storing. Store your tent in a dry place.
8) To clean, hand wash with a sponge using mild soap
Never use a washing machine or detergent.
9) Stake the tent to the ground through the corner pins and
side webbing loops.
10) Drape the rain fly over the tent. The rain fly side that
says “Vehicle Side” goes towards the vehicle. Hook the
rain fly to the bottom rings on the tent. Hook the Velcro
tab around the pole.
Slide the rain fly pole through the pole sleeve in the
rainfly sleeve above the door. Place both ends into the
grommet hole at each corner of the rain fly. Stake out
the rain fly guide ropes to the ground.