Napier BACKROADZ 19 Series User manual

CAUTION
•Keep all flame and heat sources away from the tent fabric.
The tent is made with flame-resistant fabric which meets
CPAI-84 specifications. This does not make it fireproof.
The fabric will burn if left in contact with any flame source.
The application of any foreign substance to the tent fabric
may render the flame-resistant properties ineffective.
•To prevent carbon monoxide from entering the vehicle and
tent area, do not run the engine, do not cook inside the tent,
and do not use a gas heater in the tent. Carbon monoxide is
dangerous to your health.
•Engine must be off and exhaust must be fully cooled before
tent installation and use.
•Do not use candles, matches, or open flames of any kind in or
near the tent
•Do not cook inside the tent
•Build campfires downwind and several meters away from the
tent. Be sure to fully extinguish fires before leaving a
campsite or before retiring for the night
•Exercise extreme caution when using fuel-powered lanterns
or heaters inside or around the tent. Use battery-operated
lanterns whenever possible
•Do not refuel lamps, heaters, or stoves inside the tent
•Extinguish or turn off all lanterns before going to sleep
•Do not smoke inside the tent
•Do not store flammable liquids inside the tent
•NEVER run the vehicle engine when the tent is attached
•Do not install the tent when the temperature is below
0ºC/32ºF or when your vehicle is wet, it may cause damage
•Allow adequate ventilation inside the tent at all times
•Do not attempt to drive the vehicle with the tent attached
CAMPSITE SELECTION
•Select a smooth, level campsite clear of rocks,
branches, and other hard or sharp objects
•Avoid areas with overhead power lines and tree limbs
•Park the vehicle in the chosen campsite
•Turn the engine off and engage the parking brake
WARNING
HOW TO STORE
WARRANTY INFORMATION
1. Clean and dry the tent
2. Fold all of the components into the tent
3. Roll the tent, using the pole bag as a guide
4. Secure with the tent tie straps and insert
into the carrying bag
5. Store in a cool, dry place
Napier tents have a one (1) year warranty period from the time of purchase against defects in improper
workmanship. Normal wear and tear, seam leakage through needle holes, and improper use, abuse, or
alteration are not covered under the warranty policy. Napier Outdoors will replace or repair defective parts.
Replacement parts may be new or re-built at Napier’s sole discretion. E-Warranty claim forms can be
completed online at www.napieroutdoors.com/warranty. Proof of purchase (receipt) must be provided. If you
do not provide proof of purchase, or if your warranty period has ended, replacement parts can be purchased.
To order replacement parts, contact Napier Outdoors at 800-567-2434 (9:00 am – 5:00 pm EST),
visit www.napieroutdoors.com, or email [e-mail]
BEFORE
YOU BEGIN
TRUCK TENT
19 SERIES
instructions
REV 1 - 08/14/19

NOTE: Do not attach pole clips until all poles are in place in their pockets (step 7). Failure to do so will create too much tension and may cause pole to break.
Lay the tent flat inside the bed of the truck, ensuring
the front door is at the tailgate.
Locate the tent side straps (3 per side) and loosely
attach each to the truck’s body.
Locate the tent tailgate straps (3). Slide the back 3
straps between the truck box and the tailgate (you may
need to lift the tailgate). Locate the front straps at the
end of the tailgate and connect
to the corresponding back
strap under the tailgate.
1
PACKAGE CONTENTS
tent set up
2 3
TENT BAG TENT TIE
STRAPS (2) TENT POLE BAG TENT POLES (4) RAINFLY GEAR LOFT
Black (2) 144.5” - 166.5” Corner-to-Corner
Green (1) 76” – 89” Front-to-Back
Grey (1) 145.6” – 150” Vestibule/Tailgate
Remove contents from the bag and ensure you have all components listed below.
If you are missing parts, please contact Napier Outdoors at 800-567-2434 | Monday - Friday or email [e-mail]
For an easier assembly, set the tent up on the
ground, completing steps 1-3 last.

Insert each pole into the corresponding
colored pockets in the following order:
• GREEN (front-to-back) pole
• BLACK (corner-to-corner) poles
• GREY (side-to-side tailgate) pole
Locate the front of the rainfly that goes over the door (it will have a black Backroadz tag
on the side). Drape the rainfly over the tent.
Secure the rainfly strap clips to the tent (2 per side and 2 at the tailgate) and tighten if
necessary.
10
11
Assemble the tent poles by
unfolding each section.
POLE LOCATION
Black Poles Corner-to-Corner
Green Pole Front-to-Back
Grey Pole Vestibule/Tailgate
Insert the poles into the corresponding color sleeve in the following
order (do not place the poles in the corner pockets at this time):
•Insert the BLACK pole diagonally, corner-to-corner on the roof
of the tent. Repeat with the other black pole.
•Insert the GREEN pole front-to-back on the roof of the tent.
•Insert the GREY pole side-to-side at the front (tailgate)
of the tent. Ensure the tailgate pole is even on both sides.
NOTE: The poles may get
stuck in the sleeve. Do not
force them – gently guide
the pole through the
fabric sleeve.
45
Once the tent is fully raised, attach the
pole clips to the poles.
7
If the tent straps on the side of the tru
ck are too loose, pull to tighten.
Ensuring not to make them too tight.
To install the gear loft, place each
corner hook of the gear loft into the
loop located on the ceiling of the tent.
8
9
6ATTACHING THE RAINFLY
GREEN
BLACK
BLACK
GREY
NOTE: Ensure tailgate pole is set-up on
the outside of the tailgate wires. (If pole
is set up inside the tailgate wires it will
create too much tension and may cause
pole to break).