Narita NTK-007 Reference manual

®
RITA U1
INTRODUCTION MANUAL OF
ETTLE
Please read this manual carefully before use

.-
How to use the Kettle: -
1. Make sure you have read and understood the section on general safety before
continuing.
2. Before you use for the first time, fill water up to maximum and boil. Then discard the
boiled water, let the kettle cool, rinse it thoroughly. Repeat this three times to remove
any dust, etc.
3. The kettle is designed to use throughout the world. This has been achieved by using
twin heating elements. One to operate at 11O/120v and the other to operate at
220/240v. The underside of the kettle contains a voltage selector which needs to be
turned to the correct voltage for the country/region one is in. To do this, insert a
screwdriver into the selector and rotate the arrow to the correct voltage.
4. Fill in the required amount of water ensuring the water is above the "Min" mark but not
above the "Max" mark.
Warning: If the water is over filled, there is arisk that boiling water may be ejected
and the performance of the kettle may be adversely affected.
5. Do not tilt the kettle backwards when filling or carrying.
6. Ensure the kettle lid is closed when filled before plugging the kettle power cord into the
power socket. If the lid is not in position, the kettle will not automatically switch off and
hot water will spill out of the kettle.
7. Once the kettle is plugged into the power socket, press the power on switch "Reset".
The neon light will illuminate to indicate that the kettle is connected and has started to
heat up.
8. When the water boils, the kettle will switch itself off and the neon light will go out.
9. Unplug the kettle from the power socket before pouring.
1O.Pour the boiled water slowly to avoid the risk of splashing.
11. To reuse after boiling, ernpty the kettle to allow it to cool slightly.
Note: If hot water is left in the kettle this will prevent the thermostat from setting. If you
want to switch the kettle off before the water boils, sirnply unplug it. This will not affect
the performance of the kettle .
.Water Scale and removal:
1. There may be a case that the water inside the kettle appears cloudy or greasy when
boiling. This is caused by calcium carbonate: a harrnless naturally occurring rnineral
within the water and may become apparent when water is boiled.
2. To minimize the scale build up, empty the kettle and rinse it thoroughly after each use
and never leave the water in the kettle over night.
3. It is suggested to remove the scale by boiling water with a mixture of white vinegar
and leave it over night and then rinse the kettle thoroughly.
Cleaning Your K!~e: _
1. Before cleaning make sure the kettle is unplugged from the power source and that it
has cooled down.
2. Clean with a damp cloth and if necessary use a little bit of liquid (no harsh abrasive
cleaning agents)
3. Wipe the kettle until it is completely drop before storing it.

General Safety: .
1. It is imperative that you select the correct voltage before using. Fejlure to do so will
damage kettle.
2. When in use, position the kettle on a firm, level surface, close to the power sOC:o(el
and out of reach of children.
3. Do not use in the bathroom or near any source of water or where any liquids are
present.
4. Do not place the kettle or the power cord on or near any hot surface (including hot
plates of burner) ..
5. Do not let the power cord hang over the edge of the work surface or touch hot
surfaces.
6. Do not allow children to use the kettle.
7. Even thought the kettle has the function with boil dry protection, but never use it
without water. If the function of boil dry protection has turned off the kettle, please
let it cool down completely before re-use.
8. The kettle must not be covered during use.
9. Do not pour anything while the kettle is switched on.
10. When cleaning the inside of the kettle, do not use a screwdriver or fork or any items
of similarity as these may cause damage to the heating plate.
11.The kettle should not be moved or touches when in use. Do not leave the kettle
unattended when it is in the process of boiling water.
12. Always unplug the kettle from the power socket aHer use and let it cool completely
before cleaning and storing it.
13.Remove the water scale from the kettle frequently, as large build up of scale may
affect performance and reduce the life span of the heating plate.
14. When cleaning, never let the cord come in contact with water or any other liquids.
15.The kettle is only made for boiling water; heating milk or other liquids may damage
the kettle.
WARNING: THE APPLIANCE MUST BE EARTHED
Do not operate the kettle with a damaged power cord or plug. If it is damaged, return it
to our service department for repair. This kettle is for household use only. Do not use
outdoors.
The attached plug is for use in United States, dual voltage for world wide use
(some countries may need a plug adapter).

GETTING TO KNOW OUR KETTLE
-- power on button
-- Kconindimtor
IMPORTANT-Please Keep these instructions safely for future reference not
in accordance with the instructions on using the kettle, will invalidate the
guarantee.
This unit is warranted for defective materials or workmanship for one
year from the date of purchase.The warranty is valid for any
manufacturing defects only. This warranty covers operational defects
incurred in normal use and does not apply in the case of damage,
abuse, mishandling, accident, or failure to follow operation
instructions. Narita shall have no responsibility for any damages
incidental to equipment and its sole responsibility shall be for the
repair of replacement as indicated, except for shipping and handling
costs. There are no implies or expressed vyarranties of fitness
_~o,r:..l1'l§rchantabiiity which extend beyond the above warranty.
Note: Any unit for reimbursement or repairing should be sent
back with original complete box to the authorized service
representative.