NASAB Easyup 5000 Series User manual

Totally boltless and clipless shelving
Assembly time greatly reduced
Four interlocking components form a rigid unit
Shelves adjust independently on 1" centres,
even after installation
ADD-ON UNIT
BASIC UNIT
STEP 1 - Connect Frame Connectors (FC) to Posts
A. Insert FC's into sides of Posts (Locking Tabs to be pointed UP).
(Lay Posts on floor with seams facing out, start at top and work down).
B. AS EACH FC IS INSTALLED tap FC's sharply with rubber mallet until
inserted and secure the Locking Tabs of FC's with a slot screwdriver.
C. Leave 12" from top and bottom. If third FC is required, place
in middle.
STEP 2 - Insert Upper & Lower Beams STEP 3 - Remaining Shelf Levels
A. Select two FRAMES with half slots up.
B. Connect Top and Bottom Beams.
A
. Insert the remaining BEAMS
C. Lay Particle board Shelves on top and bottom B. Repeat the procedure for ADD-ON units.
to square first unit.
5000 SERIES EASYUP - ASSEMBLY INSTRUCTIONS
5000 SERIES EASYUP - ASSEMBLY INSTRUCTIONS
Half Slot Faces UP
NORTH AMERICAN STEEL EQUIPMENT COMPANY LTD.
300 Hopkins St., Whitby, Ontario L1N 2B9 Canada
Tel: [phone] Fax: [phone] E-mail: [email protected]
Post - 74" x 86" - Use 2 FC's
Post - 98" - Use 3 FC's
Starter Unit
Adder Unit
4.0/C-ProdInfo/5000/4Z1-AssemblyInstructions.xls

STEP 4 - Shelf sits inside beam
Install FOOT PLATES, if required.
Install Postcaps.
Postcaps - (optional)
B. Shim POSTS prior to loading the SHELVES.
Footplates - (optional)
A. Where floor is uneven install SAFETY
CLIPS on top and bottom BEAMS.
Safety Clips
NORTH AMERICAN STEEL EQUIPMENT COMPANY LTD.
300 Hopkins St., Whitby, Ontario L1N 2B9 Canada
Tel: [phone] Fax: [phone] E-mail: [email protected]
4.0/C-ProdInfo/5000/4Z1-AssemblyInstructions.xls