Nature Power 23107 User manual

1
SOLAR LAMP POST WITH PLANTER
!"#$%&'$()"*+,"&,-*.*!"#$%&'()*)*
Item #23107
+,-'.( /&0( 1"#/( 203,( 4&#( 3,&&$%'5( -( 6-70#"( 8&9"#( 8#&:037;( <&#( 4070#"( #"4"#"'3"=( >?"-$"(
3&2>?"7"(7,"(&9'"#@$(#"3&#:(A"?&9B(
(
((((((C&:"?B(DDDDDDDDDDDDDDD( ( ( ( ( 80#3,-$"(E-7"B(DDDDDDDDDDDDDDD(
(
F-1"(7,"(#"3"%>7(-':(7,"$"(%'$7#037%&'$*(G7(%$(%2>&#7-'7(7,-7(/&0(#"-:(7,"("'7%#"(2-'0-?(7&(
A"3&2"(4-2%?%-#(9%7,(7,%$(>#&:037(A"4&#"(/&0(A"5%'(0$%'5(%7*( (

2
+,%$(2-3,%'"(%$(:"$%5'":(4&#(3"#7-%'(->>?%3-7%&'$(&'?/*(+,"(:%$7#%A07&#(3-''&7(A"(#"$>&'$%A?"(4&#(%$$0"$(
-#%$%'5(4#&2(2&:%4%3-7%&'*(H"($7#&'5?/(#"3&22"':(7,%$(2-3,%'"('&7(A"(2&:%4%":(-':I&#(0$":(4&#(-'/(
->>?%3-7%&'( &7,"#( 7,-'( 7,-7( 4&#( 9,%3,( %7( 9-$( :"$%5'":*( G4( /&0( ,-1"( -'/( J0"$7%&'$( #"?-7%1"( 7&( -(
>-#7%30?-#( ->>?%3-7%&'=( EK( 6K+( 0$"( 7,"( >#&:037( 0'7%?( /&0( ,-1"( 4%#$7( 3&'7-37":( 7,"( :%$7#%A07&#( 7&(
:"7"#2%'"(%4(%7(3-'(&#($,&0?:(A"(>"#4&#2":(&'(7,"(>#&:037*(
(
<&#(7"3,'%3-?(J0"$7%&'$(>?"-$"(3-??(/0122031102342*(
(
567689:*;9<6=>*8?:6;*
*@987!75A*
L"-:(3-#"40??/(-':(0':"#$7-':(-??(9;;6+B:>*97C*DE689=!D7*!7;=8?F=!D7;(A"4&#"(&>"#-7%'5*(
<-%?0#"(7&(4&??&9(7,"($-4"7/(#0?"$(-':(&7,"#(A-$%3($-4"7/(>#"3-07%&'$(2-/(#"$0?7(%'($"#%&0$(>"#$&'-?(
%'M0#/*(
(
F9?=!D7A*C)*")$*,--)G*HI%#)"#*$)*)HI%,$I*)%*,##IJK-I*$L(#*#)-,%*H)#$*-,JH*&"$(-*$LIM*
L,NI*%I,O*$L(#*J,"&,-*,"O*L,NI*OINI-)HIO*,*$L)%)&PL*&"OI%#$,"O("P*)Q*L)G*$LI*#)-,%*H)#$*-,JH(
G)%R#S*
(
@987!75A*=LI* G,%"("P#T* ',&$()"#T* ,"O* ("#$%&'$()"#* O(#'&##IO* ("* $L(#* ("#$%&'$()"*
J,"&,-*',"")$*')NI%*,--*H)##(K-I*')"O($()"#*)%*#($&,$()"#*$L,$*')&-O*)''&%S*G7(20$7(A"(0':"#$7&&:(A/(
7,"(&>"#-7&#(7,-7(3&22&'($"'$"(-':(3-07%&'(-#"(4-37&#$=(9,%3,(3-''&7(A"(A0%?7(%'7&(7,%$(>#&:037=(A07(
20$7(A"($0>>?%":(A/(7,"(&>"#-7&#*(
(
;9U6*=V6;6*!7;=8?F=!D7;*
PARTS & HARDWARE LIST
PART#
DESCRIPTION
QUANTITY
A
Lamp Head
1
B
Metal Hanger
1
C
Upper Post
1
D
Middle Post
1
E
Lower Post
1
F
Lamp Post Base
1
G
Top Planter Base
1
H
Bottom Planter Base
1

3
I
Support Ring
1
J
M6 Screw
3
K
Flat Washer
3
L
M10 Nut (Hex Nut)
6
M
Acorn Nut
3
N
M10 Bolt
3
O
J-Bolts
3
P
Mounting Plate
1
Part Detail
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.

4
ASSEMBLY INSTRUCTIONS
Lantern Assembly
Figure 1
1. (SEE FIGURE 1) Put lantern body onto the
lamp head (A) then turn clockwise to secure.
Planter Base Assembly
Figure 2
Note: If using ground mounting instead of
Planter base mounting refer to “Ground
mounting” on page 3.
1. (SEE FIGURE 2) Attach lamp post base (F)
to Bottom planter base (H) using M10 bolts (N),
mounting plate (P), Flat washer (K) and hex Nut
(L). Make sure the mounting plate, flat washer
and hex nut are secured to the hex bolt on the
underside of the bottom of the planter base (H).
Figure 3
2. (SEE FIGURE 3) Attach the top planter base
(G) To the bottom planter base (H) by lining up
the
4 tabs and pulling the top planter base up until
Tabs snap into place. Turn the top planter base
Clockwise to lock the tabs into place.
Note: It may be necessary to put pressure on
The bottom planter base when pulling the Top
planter base up.

5
Support Ring Assembly
Figure 4
1. (SEE FIGURE 4) Place the support ring (I)
onto the top of the lower post (E). Attach lower
post (E) to lamp post base (F) using 1 in.
screw(J) in 3 places. Lower the support Ring
down the post until it rests on the top of
The top planter base (G). To complete the solar
Lamp post with planter go to “Lamp Post
Assembly” steps 2,3 and 4 on page 4.
CAUTION: To prevent product damage or
personal injury from tip-over, lamp post planter
base must be placed on a flat, level surface and
be filled with 4 in. (minimum of 40 lbs.) of gravel
or stone.
Damage due to improper site selection, weighting
or stabilization of the Lamp Post is not covered
by Warranty.
Alternate Ground Mounting
Figure 5
1. (SEE FIGURE 5) Thread hex nut (L) onto the
J-bolt (O). Make sure the hex nut is threaded
down the j-bolt far enough for the top of the J-bolt
to fit through the mounting plate (P) and the lamp
post base (F) with enough threads to secure the
base to the J-bolts with acorn nuts(M). Repeat
the step for other j-bolts.
2. Using the mounting plate (P) as a guide insert
the J-bolts with hex nuts into a wet concrete pad
until the hex nuts are below pad level.
3. Place the mounting plate (P) onto the J-bolts
forming a mounting bracket.
4. Align the lamp post base (F) holes with the
J-bolts and secure with the acorn nuts (M).
Note: Refer to “Lamp Post Assembly” on page 4.

6
Lamp Post Assembly
Figure 6
1.(SEE FIGURE 6) Attach the lower post (E) to the
lamp post base (F) using 1 in. screw (J) in 3 places.
2. Place the completed lamp head (A) through the
metal hanger (B) on the upper post (C) and twist
clockwise to secure.
Note: If using the planter base to mount the lamp
post, refer to Figure 4 before proceeding to the next
step for lamp post assembly.
3. Place the middle post (D) onto the lower post (E)
and twist clockwise to secure.
4. Place the upper post (C) onto the middle post (D)
and twist clockwise to secure.

7
OPERATING SOLAR LIGHT
Instructions for First Time Use
Allow Lamp Post to charge for at least 8 hours in full sunlight with the ON/OFF switch in
the OFF position. Once the batteries are fully charged, set the ON/OFF switch to the
desired setting.
Note: If the Lamp Post does not turn on after initial charging, ensure the batteries are
making contact with the terminals and the ON/OFF switch is in position ”L” or ”H”.
Where to Place the solar Light
Place the Lamp Post in an area where it will receive direct sunlight for at least 8 hours per
day. The number of hours of nighttime illumination is directly proportional to the number of
hours of sunlight it receives. If the light is placed in a shaded area, it will not be able to fully
charge and its duration of illumination will be limited. Do not place the Lamp near other
outdoor lighting like porch or street light- it may deceive the auto sensor and keep the light
from coming on, or cause it to turn off automatically.
On/Off Switch
(SEE FIGURE 7) Slide the ON/OFF selector
Switch to the desired position:
Position
Function
Comments
Figure 7
“OFF”
OFF
Initial use or
Re-charging after
battery replacement
“L”
Low
Brightness
Auto Dusk to Dawn
Operation-8 hours
Run time
“H”
High
Brightness
Auto Dusk to Dawn
operation-5 hours
Run time

8
CARE AND MAINTENANCE
Care Instructions:
1. Clean any dirt and debris from the solar panels. The panels cannot recharge if
obstructed. Use a soft cloth to clean the panels. Do not use abrasives or chemicals
that might scratch or damage the UV coating.
2. In a region where snow and ice are likely, the batteries are required to be charged for at
least 8 hours if the assembly is covered with snow for an extended period of time.
Battery Replacement:
Figure 8
Note: The batteries in your solar panel come
preinstalled from the factory.
1. (SEE FIGURE 8) Remove the screws from
the underside of the solar panel housing. Solar
panel housing is located on the top of the
lantern assembly.
2. Carefully lift the solar panel off the housing.
Circuit wires are attached to the solar panel,
Be careful not to disconnect the wires.
Batteries compartment is located under the
Solar panel.
3. Remove old batteries.
4. Replace old batteries with 3”AA” rechargeable Ni-Nh batteries. Reference polarity
direction inside battery compartment.
5. Replace the solar panel on the housing and Secure with screws retained from step 1.
6. The rechargeable batteries need to be fully charged before operating light assembly.
See ”Operation Solar Light” to restore solar light assembly to full operation.
Recycling
Please dispose of batteries properly.
Consult your local telephone listings for a battery recycling center in your area.
*

9
+9!7=6797F6*
+,("$,("*M)&%*#)-,%*-,JH*H)#$S*G7(%$(#"3&22"':":(7,-7(7,"(5"'"#-?(3&':%7%&'(&4(-'/($&?-#(?-2>(>&$7(
A"("N-2%'":(A"4&#"(%7(%$(0$":*(O?"-'(7,"($&?-#(2&:0?"(9%7,(-(:-2>(7&9"?(7&(%'$0#"(&>7%202(
>"#4&#2-'3"(&4(7,"($&?-#(>&$7(?-2>*(E&('&7(0$"(-'/(7/>"(&4($&?1"'7(4&#(3?"-'%'5(-':(A"(3-#"40?('&7(7&(
>07(7&&(203,(>#"$$0#"(&'(7,"(2&:0?"(9,%?"(3?"-'%'5**
(
:!+!=6C*@98897=>*
6-70#"(8&9"#(9-##-'7$(&0#(>#&:037$(7&(7,"(&#%5%'-?(>0#3,-$"#(7,-7(7,%$(>#&:037(%$(4#""(4#&2(:"4"37$(%'(
2-7"#%-?$(-':(9&#.2-'$,%>(4&#(7,"(>"#%&:(&4(&'"(/"-#(4#&2(:-7"(&4(>0#3,-$"*( (
C,$IO*E%))Q*)Q*E&%'L,#I*(#*%IW&(%IOS* *
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
(
E-I,#I*')"$,'$*7,$&%I*E)GI%*E%)O&'$#*$)*,'W&(%I*J)%I*("Q)%J,$()"*)%*$I'L"(',-*#&HH)%$A(
)PQRRPSQQPRSTR(
%'4&U'-70#">&9"#>#&:037$*3&2(
999*'-70#">&9"#>#&:037$*3&2(