www.naxa.com Page 7
Using Bluetooth®Mode
Pairing a Device with Bluetooth®
A device must be paired with the speaker before using
them together for the rst time.
Make sure Bluetooth®is enabled on your device be-
fore attempting to pair it.
Set your speaker to Bluetooth®mode (press and hold
[M]). The speaker will automatically search for a paired
device. If it nds a paired device, it will connect to it
automatically, and you’re ready to play music from
that device.
If it does not detect a paired device, it will switch to
Pairing mode (the speaker will emit an ascending
4-note tone). When the speaker is in Pairing Mode, it
will announce itself to nearby Bluetooth®devices and
accept pairing requests from them.
1. The speaker will announce itself as “NAXA NAS-
3073.” Use your device to search for nearby Blue-
tooth®devices. (This function is usually in the
Bluetooth®settings menu; refer to your device’s
instruction manual to learn more.)
2. Select the speaker from the list of found devices.
3. If your device asks for a passcode, use “0000” to
complete the pairing process.
When the speaker is paired and connected to a device,
the speaker will emit a short tone.
If the pairing process fails, turn the speaker
off, set the speaker to Bluetooth®mode, and
then repeast steps 1-3.
Make sure that the volume of your device is
set to its maximum level; use the speaker to
adjust the volume to a comfortable level.
The speaker cannot be paired with more
than one device at a time.
