NEC NEC Hiperwall User manual

HIPERWALL SOFTWARE
Video Wall Control Software
Quick Start Guide Version 2.0

Hiperwall Quick Start
1. Network Configuration
Configure DHCP server, static addressing recommendedfor most
nodes
Configure switch to enable IGMP snooping and IGMP querier
Turn OFF Broadcast/Packet Storm protection
Turn OFF CPU protection, if any
Optionally connect switch to a router
Confirm that all nodes are connected at 1Gbps speed
2. Control Node Installation
Set static IP address
Install QuickTime for Windows (http://quicktime.apple.com)
Install Google Earth (http://earth.google.com)
Install VNC Server (http://www.realvnc.com/products/free/4.1)
Run Hiperwall Control Node Setup
3. Display Node Installation
Install VNC Server (http://www.realvnc.com/products/free/4.1).
Set VNC password and open firewall port.
Verify VNC connectivity from Control Node
Set static IP address
Name Display Nodes according to A1, A2… naming scheme
(recommended)
Install QuickTime for Windows (http://quicktime.apple.com)
Install Google Earth (http://earth.google.com)
Run Hiperwall Display Node Setup
NOTE: If system uses write-protected flash drives (e.g. EWF), run
EWF utility to commit changes
Reboot Display Node
Enable Wake-On-LAN and Wake-On-LAN from Standby with Magic
Packet
4. Sender Node Installation
Set static IP address for local, permanent sender nodes
DHCP may be used for temporary or remote sender nodes
Name the PC with an appropriate, meaningful name (e.g. Sender1)
Run Hiperwall Sender Node Setup
Copy Sender shortcut to startup folder if desired to automatically
start Sender after each boot
5. Streamer Node Installation
Set static IP address
Name the PC with an appropriate, meaningful name (e.g.
Streamer1)
Run Hiperwall Streamer Node Setup
Copy Streamer shortcut to startup if desired to automatically start
Streamer after each boot
Edit Shortcut to automatically queue up one or more streams
6. Secondary Control Node Installation
Set static IP address
Run Hiperwall Secondary Control Node Setup
Copy Secondary Control Node shortcut to startup folder if desired
to automatically start Secondary Control after each boot
7. System Configuration
Start Control Node Software
System will automatically display settings dialog box
Enter all appropriate system settings and save
Hiperwall system is now ready for use
© NEC Display Solutions Europe
Page 2