NetComm NB12WD User manual

NB12WD – Quick Install Guide
Unpack your NB12WD ADSL2+ Wireless Router and check you have the
following items
• NB12WD ADSL2+ Router
• 15VDC 1.6 Amps power supply
• 2x RJ-11 ADSL Line connection cables
• RJ-45 10/100 Ethernet cable
• User Guide and Driver CD
• This printed Quick Start Guide
• 1x DECT handset
• 1x Charging Dock for handset
• 1x Power Supply for charging dock
• 2x AAA batteries with battery cover for handset
• USB 2.0 cable
If you have all the items listed above please turn over for instructions on
getting started with your new Gateway.
Let’s get started >

NB12WD – Quick Install Guide
PC or MAC
PC or MAC
PC or MAC
PC or MAC
Telephone
Wall Socket
Telephone 1
Telephone 2
Splitter/Filter
PC or MAC
Printer
2.4GHz 11g
1.8GHz
Compatible
DECT
Laptop
Internet
Connecting your device
1. With the supplied Ethernet cable, connect your computer
to any LAN port on your NB12WD.
2. Connect your telephone wall socket to an ADSL Splitter/
Filter (not supplied).
3. With one of the supplied telephone cables, connect the
socket labelled ADSL on your NB12WD to the socket
labelled ADSL on your ADSL Splitter/Filter (not supplied).
4. If you wish to use Lifeline backup function (in case of an issue
with your VoIP service), please ensure that:
a. the Line port of the NB12WD is connected to the
socket labelled PHONE on the ADSL Splitter/Filter
AND
b. Please also ensure that your telephone handset
is connected to one of the ports on your NB12WD
labeled Phone1 or Phone2.
5. Connect the supplied Power Adapter to the wall power
outlet and to the socket labeled Power on the NB12WD.
6. Switch on your NB12WD at the power outlet and press
the on/off button to the ON position and wait 1 minute for
it to power up.
7. Open a web-browser on your computer and browse to
192.168.1.1.
8. When asked for a username and password, enter the
default of admin into both fields.
9. Select Quick Setup from the menu on the left, and follow
the instructions to establish your Internet connection.
Using DECT
To use a DECT handset you must first have a VoIP account
configured (see below) or have your phone line plugged into
the LINE port on your NB12WD (as in above diagram).
To register a DECT Handset with the NB12WD, hold down the
PAGE button on the side panel of the NB12WD until the green
LED labeled DECT lights up. Next go to the Register menu of
your DECT Handset and enter in the PIN - 1590.
Detailed instructions on setting up the supplied DECT handset
can be found in the separate DECT User Guide (on CD).
Using VoIP
To configure VoIP on your NB12WD, please refer to page 93 of
the User Guide – 7.7 About SIP and VoIP .
Establishing a Wireless Connection
You can connect multiple wireless devices, including laptops,
desktops and PDAs by following these 2 basic steps
1. Using your device, scan for wireless networks in your
area, select the network called NetComm Wireless and
click connect
2. Enter the following default security key: a1b2c3d4e5
Note: To ensure wireless security, we recommend you change the default
settings in the User Interface. For more detail, see your User Guide.