NETGEAR N300 User manual

Netgear N300 configuration guide
certified router

RingCentral certified router Netgear N300
1. Open your browser and navigate to http://192.168.1.1.
2. Log in to the router. The default username is “admin”. The default
password is “password”.
3. Select the “Advanced” tab and the select “WPS Wizard” on the
left hand side.
4. Select “Setup”.
5. Select “QoS Setup”.
Configuring QoS on the Netgear N300
to Prioritize VoIP Traffic
Brand: NetGear
Model: N300
Hardware Version: WNR3500Lv2
Firmware Version: V1.2.0.16_40.0.66
2
1
3a
4
5
3b

RingCentral certified router Netgear N300
6. Check the box next to “Turn Internet Access QoS On” if not
already checked.
7. Check the box next to “Turn Bandwidth Control On”.
8. Select the “Uplink bandwidth Maximum” radial button.
9. In the field to the right of the radial button enter in your current
upload speed. (If unsure of the current upload speed, run a
speedtest at http://www.ringcentral.com/support/capacity.html).
10. Be sure to save any changes and reboot the router
before proceeding.
11. Your QoS should now be configured.
6
7
9
8
10