Step 3 Assembling Upper Bunk
DO NOT FULLY TIGHTEN ANY BOLTS UNTIL ALL UPPER BUNK PIECES ARE CONNECTED
The Upper Footboard should be positions so the Post with the two holes is facing towards the front.
Back Side –Use the holes that are at the back of the bunk head & footboards to make the following connections
Attach mattress side rail (E) to upper Headboard (C) into the bottom two holes of the headboard. There a six
holes in the headboard; make sure to secure the mattress rail to the bottom two.
Attach the upper footboard (D) using the Barrel Nuts (P) and Rail Bolts (N). (As in Step 1).
WARNING Label on Headboard must face out away from bed.
Front Side- Use the holes that are at the front of the bunk head & footboards to make the following connections
Attach Front Ladder Side Rail (EL) to headboard (C) and foot board(D).
Install Mattress Support Slats (F) as in step 2
Attach Guardrails: (Curved edge of all guard rails must be facing down)
Attach 2 - 74”Guardrails (G) to the back portion of the upper bunk using the steps described in Step 1. The
curved edge must be facing down.
Mount Guard Rail Post (L) to the front side of Ladder Side Rail (EL) using 2- 1 ½” bolts (M). No Barrel Nuts are
required.
Attach 2- 57”Guard Rails from the Guard Rail Post (L) to the foot board (D) using 3 3/4”Rail Bolt (N) and
Barrel Nuts (P). Curved edge of both Guard Rails must be at the bottom facing down.
Tighten all bolts.
