Newborn VR400-XSP User manual

•
•
•
•
VR400-XSP
S am S al r Applicator for 400 ml Cartridg
Mo el VR400-XSP comes assemble rea y for 1:1 ratio use with 400 ml cartri ges. See instructions below for conversions of 2:1, 4:1, an
10:1 cartri ge ratio use.
Instructions for R moving Push Disks
1) Place applicator with knob on floor.
2) Put both thumbs on front plate an fingers behin the isk you esire to remove.
3) Move fingers forwar towar thumbs until isk snaps off ro . If the isk is har to remove, use a rubber mallet an gently tap until isk
becomes loose.
4) See Disk Ass mbly Diagram for proper ratio alignment.
Instructions for Attaching Push Disks
1) Put socket of push isk over ro shaft.
2) Push firmly onto the ro shaft until isk snaps in place. There shoul be two snapping soun s which will ensure the isks are firmly
attache . Some twisting of the push isk may be require to achieve the secon snap.
3) Both isks shoul be parallel with each other. This will ensure proper mixing of materials.
•
•
•
•
1:1
2:1
4:1
10:1
DISK ASSEMBLY DIAGRAM
28 mm
28 mm
34 mm
42 mm
42 mm
46 mm
12 mm
19 mm
FRONT PLATE
LRIMPORTANT: Disks must be on the correct si e of the
piston ro . If you are facing the outsi e of the front plate
(see iagram), the isks un er “L” shoul be on the left
han si e an the isks un er “R” shoul be on the
right han si e of the piston ro .

1:1
•
•
•
•
2:1
4:1
10:1
VR400-XSP
S am S al r Applicator for 200 ml Cartridg
See instructions below for conversions of 1:1, 2:1, 4:1, an 10:1 cartri ge ratio use.
Instructions for R moving Push Disks
1) Place applicator with knob on floor.
2) Put both thumbs on front plate an fingers behin the isk you esire to remove.
3) Move fingers forwar towar thumbs until isk snaps off ro . If the isk is har to remove, use a rubber mallet an gently tap until isk
becomes loose.
4) See Disk Ass mbly Diagram for proper ratio alignment.
Instructions for Attaching Push Disks
1) Put socket of push isk over ro shaft.
2) Push firmly onto the ro shaft until isk snaps in place. There shoul be two snapping soun s which will ensure the isks are firmly attache .
Some twisting of the push isk may be require to achieve the secon snap.
3) Both isks shoul be parallel with each other. This will ensure proper mixing of materials.
DISK ASSEMBLY DIAGRAM
•
28 mm 28 mm
Off Center
34 mm
Off Center
34 mm
Off Center
34 mm
Off Center
19 mm
19 mm
12 mm •
•
•
FRONT PLATE
LRIMPORTANT: Disks must be on the correct si e of the
piston ro . If you are facing the outsi e of the front plate
(see iagram), the isks un er “L” shoul be on the left
han si e an the isks un er “R” shoul be on the
right han si e of the piston ro .