Newer Technology 20A-TR Power2U User manual

The Newer Technology Power2U AC/USB wall outlet oers a clean, convenient, and centralized location to charge and/or
power mobile devices along with powering traditional AC powered“plug in” items. It’s an easy DIY install on any 20A electrical
circuit and provides a ush, standard wall outlet appearance that blends in seamlessly with residential environments.
By incorporating both traditional three prong AC wall sockets along with USB ports, the Power2U AC/USB wall outlet enhances
living and working spaces by eliminating the clutter created by multiple cables and unsightly bulky power adapters.
CAUTION: Please read before installing!
 •A video installation guide is available at: http://www.newertech.com/p2u-install
 •Failuretofollowtheseinstructionscancausedeathorpermanentinjury.Donotworkonliveelectricalcircuits!
 •Thisproductisforindoorandpermanentlyinstalleduseonly.
 •Donotplacethedevicetobechargedindirectsunlightorneardirectheat,asthiswillaectthechargingfunction.
 •DisconnecttheUSBcablefromtheUSBsocketwhennotinuse.
 •ItisnormalforthebatteryinthedevicebeingchargedandtheUSBchargeritselftogeneratesomeheatduringthe
 chargingprocess.
 •Installthedeviceinaccordancewithallnationalandlocalelectricalcodes.
General Information:
 •Thisproductisa2-in-1electricalwallsocket.Itcanbeusedasastandard20A120Velectricalreceptacle,aswellasfor
 chargingproductsthatutilizeaUSBconnectionupto2.5A.ItisidealforchargingelectronicssuchasiPhone,iPad,iPod,MP3
 players,PDAs,GPSreceivers,gamingconsoles,andanyotherdevicesthatchargeusingaUSBconnection.
 •TheNewerTechnologyPower2UusesthemostadvancedICcontrolsystemintheworld,andprovidesmultiplelevelsof
 protectiontoyourdevicebeingcharged.
 •TheNewerTechnologyPower2Uismanufacturedfromhighqualitypolycarbonateresinandallinternalcomponentshave
 beenULapproved.
Identify Cables / Wires
 •DoNOTinstalltheNewerTechnologyPower2Uwalloutletintoanelectricalboxthatissmallerthan16cubicinches.Ifyour
 electricalboxcontainsmorethan4wires(notincludinggroundwires),verifythatit’scapacityislargeenoughto
 accommodatethisdevicebeforeproceeding.Do not overll the electrical box!
Wire and Wire Connections
 •The20ANewerTechnologyPower2Uisdesignedtoworkwitheithersolidwireorstrandedwire,12AWG.Whenattaching
 thewiretothePower2U,pleaserefertothedrawingsbelowtoensureproperconnection:
Wire
Wire
13mm
Stripwire13mm(1/2”)
Insertwireunderscrewblockand
torqueto14inch-pounds.Then,bend
thewire90ºafterassemblytoaid
insertionintotheelectricalbox.
Brass
Screws
Silver
Screws
Green
Screw
Brassscrews=Hot(BlackWire)terminal
Silverscrews=Neutral(Whitewire)terminal
Greenscrew=Ground(Bareorgreenwire)terminal
20A-TR Power2U®
Left side has silver screws,
and “W” near terminals.

Installation and use:
TheinstallationoftheNewerTechnologyPower2Ureceptacleisstraightforwardandthesameasreplacinganormalelectrical
receptacle.ThePower2Uisalargedevice;makecertainthatyourelectricalboxcanlegallyaccommodateit!
To install the Newer Technology Power2U:
➀ TurnthepowerOFFtothereceptacleyouarereplacing.Thisisdoneattheelectricalcircuitbreakerboxorthefusebox.
TurnthecircuitbreakerOFForremovethefusethatpowersthecircuityouareworkingonbeforeproceeding!
➁ConnectthewirestotheNewerTechnologyPower2Ubyplacingthewireintotheslotofthesteelpressureplate,tightenthescrew
to14inch-poundsoftorque,thenbendthewire90ºsothatitisatagainstthePower2U’sbody.
•The black wire connects to the brass terminal (HOT)
  •Thewhitewireconnectstothesilverterminal(NEUTRAL)
  •Thebarecopperorgreenwireconnectstothegreenterminal(GROUND)
Wire(12AWG)
outgoingpowertonext
receptacle(ifavailable)
Wire(12AWG)
incomingpower
Groundingconnection
tobox
WireNut
BlackWire WhiteWire
Insertblackwireintosloton
steelscrewplate
Insertwhitewireintosloton
steelscrewplate
Insertbareorgreenwire
intoslotonsteelscrewplate
➂Foldthewiresintotheelectricalbox,keepingthebaregroundwireawayfromtheHOT(brass)andNeutral(silver)terminals.
ScrewthePower2Uintotheelectricalbox.ScrewthefaceplateintothePower2U.
➃Turnthepowerbackontothereceptacleatthecircuitbreakerorfusepanel.TestthePower2Ureceptacle(125V)poweroutlets
andthe5.2VUSBoutletstoverifyproperoperation.TheUSBoutletsareonlypoweredwhenthesafetyswitchcoverisopenand
aUSBcableispluggedin.IfaUSBportdoesnotworkwheninstalled,pleasevisithttp://www.newertech.com/p2u-install for
troubleshootingtipsandsuggestions.
®Newer Technology, Inc. 12/23/12 JD
For support please contact us at: http://www.newertech.com/support
Patent#US7,997,925ULFile#E339607
A video installation guide is available at: http://www.newertech.com/p2u-install
Technical Specications
USBInput:AC125V50/60Hz450mA OperatingTemperature:-10ºCto35ºC
USBOutput:DC5.2V2.5A   RelativeHumidity:<=75%
ACInput:20A,125V(NEMA5-20R)