Nex-tech YN8040 User manual

Instruction Manual
YN8040
Gigabit PoE Injector

1
1 x Gigabit PoE Injector
Ethernet Port
PoE Port
LED Status Indicators
1 x Power Supply Lead
BOX CONTENTS:
PRODUCT DIAGRAM:

2
CONNECTION DIAGRAM:
LED INDICATOR DESCRIPTION:
LED Status Indicator Status Description
Power On Working
Off Power Off
PoE
On PoE Output Working
Flashing Short Circuit / Overload
Off No PoE / Power Output

3
OPERATION:
SPECIFCATIONS:
1. Connect the power supply lead in to the socket on the PoE injector.
2. Connect the mains power supply lead to a 240VAC power outlet.
3. Plug in the Ethernet cable in to the Ethernet port of the PoE injector.
4. Connect your required PoE device using an Ethernet cable (not included)
to the PoE port of the injector.
Input Voltage: 100-240VAC
Output Voltage: 52VDC
Output Current: 0.67A
PoE Output Power: 35W
Ports: 1 x RJ45 Ethernet Input
1 x RJ45 PoE Ethernet Output
PoE Standards: IEEE 802.3at, IEEE 802.3af
Network Speed: 10/100/1000Mbps
Transmission Speed: Up to 100m
Pin Assignment: Data (1/2 & 3/6), Power (1/2+ & 3/6-)
Dimensions: 118(L) x 59(W) x 37(H)mm

4
SAFETY INSTRUCTIONS:
TROUBLESHOOTING:
• Ensure the unit is placed in a well ventilated area.
• Do not position the unit close to any heating source or in direct sunlight.
• Ensure the unit does not come in to contact with any water or moisture as
it may damage the unit.
Problem Solution
Power LED not turning ON
Check if the mains power supply is properly
connected to a 240VAC Outlet
Check if the power supply lead is connected
properly to the PoE injector
Link LED not turning ON
Ensure the device you have connected is
switched on
Check that the ethernet cable is connected
properly on both the device and the injector

5

6

Distributed by:
Electus Distribution Pty. Ltd.
320 Victoria Rd, Rydalmere
NSW 2116 Australia
www.electusdistribution.com.au
Made in China