Nexo VNT-MNSTKM6 User manual
PAGE 1 OF 3
- Read this document before using.
- Keep this document.
- Observe all warnings and cautions.
VNT-MNSTKM6
DP4325/Rev01a - DI
Stacking option for GEOM6 on top of MSUB12
Contents:
X1
X1
X1
Weight: 0.14 kg / 0.31 lb
PAGE 2 OF 3
- Read this document before using.
- Keep this document.
- Observe all warnings and cautions.
Dimensions:
Use:
Place MNSTKM6 in the M20 Footprint of the MSUB12.
Place GMT-BUMPER above MSUB12 and align one hole of it with
MNSTKM6.
Insert the clevis pin and secure with “R” clip.
Connect bottom cabinet to GMT-BUMPER at required vertical angle with 4 x VXT-BL515 quick release pins
NB: Bottom cabinet angle can be adjusted from -7° to 0° in relation to MSUB12.
Connect subsequent cabinets at required inter-angle values with 4x VXT-BL515 quick release pins.
Ensure that the clevis pin is properly locked in VNT-MNSTKM6, and that 5mm pins are properly locked in
GEO M6.
•NEXO cannot accept responsibility for accidents caused by any factor other than defects in this product itself.
Table of contents
Other Nexo Speakers System manuals
