Nexo VNI-WS15 User manual

PAGE 1 OF 4
- Read this document before using.
- Keep this document.
- Observe all warnings and cautions.
VNI-WS15
DP3425/Rev01b - DI
Wall bracket for GEOM6 / LS600 / PS15
Contents:
X1 (Arm)
X1 (Adapter)
X1
X1
X2
X1
X2
X1
X1
X1
X1
Weight: 2.8 kg / 6.2 lb

PAGE 2 OF 4
- Read this document before using.
- Keep this document.
- Observe all warnings and cautions.
Dimensions:
Adapter mounting
•Connect the VNI-WS15 adapter to the
GMT-LBUMP by using the M6x20
provided with the GMT-LBUMP
•Position the M6x20 screws in the oblong
hole so that required vertical angle is
obtained
•Remove 2 screws from the LS600 / PS15 and use the 2 screws and the 2 washers
provided to fix the adapter.
•Please, do not push on the 2 screws while screwing them, to avoid disengaging
the bolt that is inside the cabinet.
No tilt with LS600
WARNING: Screws must be secured using Loctite 243TM







 










PAGE 3 OF 4
- Read this document before using.
- Keep this document.
- Observe all warnings and cautions.
Tilt in vertical position with PS15

 

 
 


PAGE 4 OF 4
- Read this document before using.
- Keep this document.
- Observe all warnings and cautions.
Adapter / Arm mounting
For the wall mount of VNI-WS15, please select screws and mounting location supporting 4 times the system
weight.
Tighten well to cancel any float between the arm and the adapter.
Safety device
!! Use the parts provided
•NEXO cannot accept responsibility for accidents caused by any factor other than defects in this product itself.
•Please check the web site nexo-sa.com for the latest update.