Nidec TF037 Series User manual

1 ) Micro Blower, Driver and Wire Harness Introduction
NIDEC COPAL ELECTRONICS offers two Micro Blower product lines:
The TF037 series which has 4 part numbers and the TF029B series which has one part number.
The TF029B only needs one harness, it is used to connect the driver to the power supply.
The TF037 requires two harnesses, one to connect the driver to the blower and the other to connect
the driver to the power supply.
-
①Micro Blower
②Driver
③Wire Harness (for
Driver-Blower
connection)
④Wire Harness (for
Driver-Power
connection)
⑤24 V Power (Not included
in kit)
TF037 series
-① -②
③- -④
⑤-
TF029B series
①-
-④
②-
⑤-

2) How to connect TF037 Series Micro Blower to the Driver
Connect the wire harness to the TF037
Micro Blower and then connect the
other end of the harness to the driver.
Note:
Both connectors on the ends of the
harness are the same.
Make sure the connector’s holding
tab is on the top side when
connecting the Micro Blower to the
driver.
*Applicable P/N’s :
TF037C-2000-F, TF037C-2100-F
TF037F-2000-F, TF037E-2000-F

3) How to connect TF029B Series Micro Blower to the Driver
*Applicable P/N’s :
TF029B-2000-F
1) The TF029B will have wire leads instead
of pins.
2) Please connect each lead wire to the pins
located on the driver via the tightening screws.
3) Connect as shown on the right.
4) An instruction manual comes with each
Micro Blower. Please refer to the manual
under the section “Connection” for details on
the pinouts of the blower and driver board.
A digital copy is also available online at our
website.
①②
③
Green
Yellow
Orange
Red
Black
Wire Color Pin No. Pin Name Contents
Green 1 TH(+) Thermistor Output (+)
Yellow 2 TH(-) Thermistor Output (-)
Orange 3 W Motor Coil (W)
Red 4 V Motor Coil (V)
Brown 5 U Motor Coil (U)

4) How to connect the driver to the power supply.
1) Connect the 6-wire harness to the driver.
Make sure the connector’s holding
tab is on the top side when
connecting the driver.
2) An instruction manual comes with each Micro
Blower. Please refer to the manual under the
section “Connection” for details on the pinouts
of the power supply and driver board.
A digital copy is also available online at our
website.
*Applicable to all models.
Wire Color Pin No. Pin Name Contents
Brown 1 Error Error Output
Red 2 FG Rotational Speed Output
Orange 3 BR/NC Short Brake Input
Yellow 4 CNT Control Voltage Input
Green 5 Vcc/VIN Power Supply Input
Blue 6 GND GND