NIFTYLIFT SP34 Reference guide
7/24/18
MANLFT/BOOM LIFT/4X4
Operating Instructions
1. Ensure all emergency stops are out
2. Turn key switch at ground control station to Basket position, fully up.
3. Ensure function selector hand valve is turned to Basket position, fully up.
4. Ensure main engine ignition switch in the engine compartment is ON.
NOTE: If turned fully right, the 3 position ignition switch will re the engine. When released, the selector
will return to the center, ON position. Once running the engine can only be turned o from the key switch
locatd in the basket.
5. Enter the basket and, as always, lower the safty bar once inside.
6. Turn the key switch right to II (for engine) or left to I (for electric mtors.) Start engine from basket (if sleected)
by turning ignition knob to the left for a fe w moments (if glow plug is needed), then to the right which will en
gage the starter motor. Once running release the ignition knob.
7. To drive the lift, or operate any of the booms, select either low (tortoise) or high (hare) throttle position then
depress and hold the green power button.
8. Select function and operate hand levers in full accordance with manufactureers operating and safety manual
(included).
9. This model of lift has six control levers in the basket, ve full size and one shortened. To operate, push the
green power button and manipulate the proper lever for desired boom/vehicle function.
10. Levers, from left to right.
1. Drive (Forward/reverse) and steer (See Back)
2. Basket angle (Short Lever in reaer of control box)
NOTE: Basket should self-level; however, air may form int he line and aect function. Use the
shortened lever to make small adjustments to the basket angle until air is purged form line.
3. Operates uppder boom telescopic feature. UP to extend DOWN to retract.
4. Operates Lower Boom - UP for up - DOWN for down.
5. Operates Upper Boom - UP for right - DOWN for left.
NOTE: Do not rotate boom while in the stowed (lowered) position as the operator step will
strike the vehicle’s tires.
11. When not in use return booms to stowed position. Turn the key switch at ground control to center OFF
position, remove key, and chock wheels.
• Before operating the Niftylift, ensure that each operator has read and fully
understands the operating manual. Failure to do so may result in death or
serious injury.
If equipment does not work properly, notify oce at once -
• Phoenix, 602-955-5100 • North Valley, 602-992-1150 • East Valley, 480-539-8700 • West Valley, 623-925-0200
Driving Controls
1. Check proposed route for possible hazards, obstructions, and personnel.
2. Push green power button.
3. Use Drive Speed selector on the basket control station to determine speed.
(Hare) - GIVES HIGH SPEED AND LOW GRADEABILITY
(Tortoise) - GIVES LOW SPEED AND HIGH GRADEABILITY
is only available when the booms are in the stowed position.
4. Select drive joy stick from the basket control box.
A. Up for FORWARD
B. Down for
C. Left for
D. Right for
5. All control levers give a fully proportional response therefore the more the lever is moved away from
the center (OFF) position the faster the function will become.
6. Maximum speed is only attainable when all booms are fully stowed and the selector is in the
position.
7. When driving with the booms fully stowed, the Tilt Alarm is bypassed to allow the Niftylift to be driven
in areas where the slope exceeds the ve-degree working limit. In normal operation the drive is
therefore unaected when driven onto a slope in excess of ve-degrees, until the booms are raised,
whereupon the drive would be disabled and the lift alarm sounds continuously.
8. Under no circumstances should any Niftylift SP series be driven on slopes exceeding 25%, with
booms fully stowed.
ALL NIFTYLIFTS ARE FITTED WITH A TILT ALARM - PRE-SET IN THE FACTORY.
ONCE ALARM IS ACTIVATED, THE NIFTYLIFT WILL LOSE ALL POWER TO DRIVE
FUNCTIONS AND A LOUD AUDIBLE ALARM WILL SOUND.
TO DEACTIVATE, LOWER THE BOOMS FULLY TO STOWED POSITION AND
REPOSITION BASE ON FIRM LEVEL GROUND.
IF ALARM SOUNDS - DESCEND IMMEDIATELY AND RE-LEVEL MACHINE BASE.
Disclaimer:
These instructions are intended as a helpful
reminder. They do not replace the full operating
instructions found in the owners manual, which
is available at the rental counter.
If equipment does not work properly, notify oce at once -
• Phoenix, 602-955-5100 • North Valley, 602-992-1150 • East Valley, 480-539-8700 • West Valley, 623-925-0200
Table of contents
Other NIFTYLIFT Boom Lift manuals
NIFTYLIFT
NIFTYLIFT nifty 90 Setup guide
NIFTYLIFT
NIFTYLIFT HR 12 Assembly instructions
NIFTYLIFT
NIFTYLIFT HR12LE MK2 User manual
NIFTYLIFT
NIFTYLIFT nifty TM Series Quick guide
NIFTYLIFT
NIFTYLIFT TM Series Quick guide
NIFTYLIFT
NIFTYLIFT HR 10 Quick guide
NIFTYLIFT
NIFTYLIFT Heightrider HR28 Series Quick guide
NIFTYLIFT
NIFTYLIFT Nifty Heightrider HR21 MK2 Series Assembly instructions
