Nilfisk-Advance Advance BU800 Installation and user guide

BU800 Battery Burnishers How To
Prepare for use
1
Unplug battery charger.
Wrap cord accordingly.
2
Check/inspect bag.
Replace bag if needed.
3
Remove the skirt.
4
Inspect pad for wear.
5
Turn pad retainer
counter clockwise to
remove the pad.
6
Install new pad and
center on outside
diameter of the pad
driver.
7
Tighten pad retainer in
clockwise direction.
8
Prep area to remove
debris.
9
Turn the key switch to
turn the machine on.
Check battery power.
10
Palm buttons power the
pad drive and causes
the pad to spin and
lower to the floor
( models without traction ).
11
Turn on pad power
switch. Press palm
buttons to drive
machine and lower pad
to the floor (traverse models)
12
Press the speed control
button to adjust traverse
speed.
Press the reverse button
while pressing palm buttons
to move the machine in
reverse
All manuals and user guides at all-guides.com
all-guides.com

BU 800 Battery Burnishers How To
Store the Machine
1
Wipe machine exterior
after each use.
2
Plug machine in
appropriate outlet to
charge batteries.
3
Remove the cover to
expose batteries for
ventilation.
BU800 Battery Burnishers How To
Maintenance
1
Charge batteries daily.
Check each battery
cell’s water level, add
water if needed.
2
Check/Replace Dust
Bags.
3
Check/Replace Skirt
4
Clean Pad. Replace as
needed.
5
Lubrication and
Check/Service Pad
Motor Brushes
6
Service Drive Motor
Brushes
Monthly Maintenance Yearly Maintenance
All manuals and user guides at all-guides.com