Nilfisk-Advance Whirlamatic 17UHS User manual

revised 4/01 FORM NO. 56041233
Whirlamatic
™
17/20UHS
OPERATOR MANUAL
Advanc MODELS 56183100, 56183105(OBS)
56183700, 56183701(OBS), 56183705
https://harrissupplyind.com-ToOrderPartsCall608-268-8080

Whirlamatic Operator Manual - 1
TABL OF CONT NTS
PAG
INTRODUCTION ...................................................................... 2
IMPORTANT SAF TY INSTRUCTIONS ................................. 3
IMPORTANT SAF TY INSTRUCTIONS ................................. 4
GROUNDING INSTRUCTIONS ............................................... 5
PR PARING TH FLOOR....................................................... 6
PR PARING TH MACHIN FOR US .................................. 6
OP RATING CONTROLS ....................................................... 7
OP RATING TH MACHIN ................................................... 8
AFT R USING MACHIN ....................................................... 8
MAINT NANC ....................................................................... 9
TROUBL SHOOTING ........................................................... 10
https://harrissupplyind.com-ToOrderPartsCall608-268-8080

2 - Whirlamatic Operator Manual
INTRODUCTION
This manual will help you get the most from your Advance Whirlamatic. Read it thoroughly before operating the machine.
References to “right” and “left” in this manual mean right or left as seen from the operator s position.
This product is intended for commercial use only.
PARTS AND S RVIC
Repairs, when required, should be performed by your Authorized Advance Service Center, who employs factory trained
service personnel, and maintains an inventory of Advance original replacement parts and accessories.
Call the ADVANCE DEALER named below for repair parts or service. Please specify the Model and Serial number when
discussing your machine.
(Dealer, affix service sticker here.)
NAM PLAT
The Model Number and Serial Number of your machine are shown on the name plate, located on the back of the machine
near the base of the handle. This information is often needed when ordering repair parts for the machine. Use the space below
to note the Model Number and Serial Number of your machine for future reference.
MODEL NUMBER _________________
SERIAL NUMBER _________________
UNCRATING
When the machine is delivered, carefully inspect the shipping carton and the machine for damage. If damage is evident, save
the shipping carton so it can be inspected by the trucking company that delivered it. Contact the trucking company
immediately to file a freight damage claim.
https://harrissupplyind.com-ToOrderPartsCall608-268-8080

Whirlamatic Operator Manual - 3
IMPORTANT SAF TY INSTRUCTIONS
When using an electrical appliance, basic precautions should always be followed, including the following:
Read all instructions before using.
WARNING!
To reduce risk of fire, electric shock, or injury:
1Do not leave the appliance when it is plugged in. Unplug the unit from the outlet when not in use and before servicing.
2To avoid electric shock, do not expose to rain. Store indoors.
3Do not allow to be used as a toy. Close attention is necesary when used by or near children.
4Use only as described in this manual. Use only manufacturer s recommended attachments.
5Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left
outdoors, or dropped into water, return it to a service center.
6Do not pull or carry by cord, use cord as a handle, close a door on a cord, or pull cord around sharp edges or corners.
Do not run appliance over cord. Keep cord away from heated surfaces.
7Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
8Do not handle plug or appliance with wet hands.
9Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair, and anything
that may reduce air flow.
10 Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
11 Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
12 Turn off all controls before unplugging.
13 Use extra care when cleaning on stairs.
14 Do not use to pick up flammable or combustible liquids such as gasoline or use in areas where they may be present.
15 Connect to a properly grounded outlet only. See Grounding Instructions.
SAV TH S INSTRUCTIONS
https://harrissupplyind.com-ToOrderPartsCall608-268-8080

4 - Whirlamatic Operator Manual
IMPORTANT S M SUR S D SÉCURITÉ
L utilisation d un appareil électrique demande certaines précautions:
LIRE TOUTES LES INSTRUCTIONS AVANT DE FAIRE FONCTIONNER (CET APPAREIL)
AV RTISS M NT:
Pour réduire les risques d incendie, de choc électrique ou de blessure:
1Ne pas laisser l appareil sans surveillance lorsqu il est branché. Débrancher lorsque l appareil n est pas utilisé et avant
l entretien.
2Pour réduire les risques de choc électrique, utiliser à l intérieur seulement.
3Ne pas permettre aux enfants de jouer avec l appareil. Une attention particulière est nécessaire lorsque l appareil
est utilisé par des enfants ou à proximité de ces derniers.
4N utiliser que conformément à cette notice avec les accessoires recommandés par le fabricant.
5Ne pas utiliser si le cordon ou la fiche est endommagé. Retourner l appareil à un atelier de réparation s il ne fonctionne
pas bien, s il est tombé ou s il a été endommagé, oublié à l extérieur ou immergé.
6Ne pas tirer soulever ou traîner l appareil par le cordon. Ne pas utiliser le cordon comme une poignée, le coincer dans
l embrasure d une porte ou l appuyer contre des arêtes vives ou des coins. Ne pas faire rouler l appareil sur le cordon.
Garder le cordon à l écart des surfaces chaudes.
7Ne pas débrancher en tirant sur le cordon. Tirer plutôt la fiche.
8Ne pas toucher la fiche ou l appareil lorsque vos mains sont humides.
9N insérer aucun objet dans les ouvertures. Ne pas utiliser l appareil lorsqu une ouverture est bloquée. S assurer que
de la poussière, de la peluche, des cheveux ou d autres matières ne réduisent pas le débit d air.
10 Maintenir les cheveux, les vêtements amples, les doigts et toutes les parties du corps à l écart des ouvertures et des
pièces mobiles.
11 Ne pas aspirer de matières en combustion ou qui dégagent de la fumée, comme des cigarettes, des allumettes ou
des cendres chaudes.
12 Mettre toutes les commandes à la position ARRÊT avant de débrancher l appareil.
13 User de prudence lors du nettoyage des escaliers.
14 Ne pas aspirer des liquides inflammables or combustibles, comme de l essence, et ne pas faire fonctionner dans des
endroits ou peuvent se trouver de tels liquides.
15 Ne brancher qu à une prise de courant avec mise à la terre. Voir les instructions visant la mise à la terre.
CONS RV R C S INSTRUCTIONS
https://harrissupplyind.com-ToOrderPartsCall608-268-8080

Whirlamatic Operator Manual - 5
• Replace the plug if the grounding pin is damaged or broken.
• Thegreen(orgreen/yellow)wireinthecordisthegroundingwire.Whenreplacingaplug,thiswire
must be attached to the grounding pin only.
• Extensioncordsconnectedtothismachineshouldbe12gauge,three-wirecordswiththree-prong
plugs and outlets. Do not use extension cords more than 50 feet (15 m) long.
GROUNDING INSTRUCTIONS
WARNING!
Thismachinemustbeproperlygroundedtoprotecttheoperatorfromelectricalshock.Readthesafety
instructions below before operating this machine.
GROUNDED
OUTLET BOX
120 VOLT PLUG
GROUNDING PIN
THREE-PRONG
GROUNDED OUTLET
GROUNDING
TAB
120 VOLT PLUG
GROUNDED
OUTLET BOX
METAL
SCREW
TWO-PRONG
OUTLET
120voltmachineshavethiskindofthree-prong
plug at the end of a three-wire electrical cord.
The grounding pin on this plug grounds the
machine when it is plugged into a three-prong
outlet.
Agroundingadaptermustbeinstalled
as shown here if only two-prong out-
lets are available. The outlet box
mustbegroundedandthegrounding
tab (or wire) on the adapter must be
installedundertheheadofthescrew
in the center of the outlet cover.
Groundingadaptersfor120voltplugs
areavailableatmosthardwarestores.
Groundingadaptersarenotapproved
for use in Canada.
https://harrissupplyind.com-ToOrderPartsCall608-268-8080

6 - Whirlamatic Operator Manual
INSTALLING A PAD
Pad Retainer
Pad
Pad Holder Hub
PR PARING TH FLOOR
Before each use of this machine, the floor must be clean and completely dry. Clean the floor with an automatic floor scrubber
or a damp mop, using a solution of water and neutral cleaner.
CAUTION!
This machine should be used only on floors that are coated with a floor finish suitable for burnishing. Contact your local
Advance Distributor for further information on floor finishing products.
PR PARING TH MACHIN FOR US
WARNING!
Moving parts - To reduce the risk of injury, unplug before servicing.
INSTALLING TH PAD
To install a pad, tip the machine back on it s handle. Remove the Pad Retainer (in the center of the pad holder) by turning
clockwise to loosen.
Put the proper size pad on the pad holder. Re-install the Pad Retainer by turning counter-clockwise to tighten.
https://harrissupplyind.com-ToOrderPartsCall608-268-8080

Whirlamatic Operator Manual - 7
OP RATING CONTROLS
1 Handle
2 Twist Grip Lock Button
3 Twist Grips
4 Power Cord
5 Handle Release Lever
123
4
5
https://harrissupplyind.com-ToOrderPartsCall608-268-8080

8 - Whirlamatic Operator Manual
OP RATING TH MACHIN
1Plug the Power Cord (4) into a properly grounded electrical outlet.
2Pull the Handle Release Lever (5) UP and lower the Handle (1) to a comfortable operating position. It is normal for the
base of the machine to lift off of the floor slightly when the handle is lowered. It will pull itself down against the floor as
soon as the motor is started.
3Push the Twist Grip Lock Button (2) IN and turn the Twist Grips (3) to start the motor. Release the Twist Grips to stop
the motor.
4Push the machine forward in a straight line, at a slow walking speed. Overlap each pass about 1 inch (25 mm). Do not
use a back and forth motion when operating this machine.
5When using a polishing pad, check every 15 minutes to see if the pad is loaded up with wax and dirt. If it is, turn the
pad over to expose the clean side, or install a clean pad.
AFT R USING TH MACHIN
1Lift the Handle until it locks in the upright position.
2Unplug the Power Cord and wrap it around the cord hook and the right Twist Grip.
3Tip the machine back and remove the pad.
4Wash the pad in warm soapy water, rinse completely and hang it up to dry. Do not use the pad again until it is completely
dry.
5Store the machine in a clean, dry place.
https://harrissupplyind.com-ToOrderPartsCall608-268-8080

Whirlamatic Operator Manual - 9
Filter
Motor Brush Wear
Indicator Light
MAINT NANC
AIR FILT R
The air filter on top of the motor must be cleaned once a month. To clean the filter, remove the 3 screws from the motor cover,
lift the cover off and remove the filter from its holder. Wash the filter with warm water and allow it to dry completely before
putting it back on the machine.
MOTOR BRUSH S
Some models are equipped with a motor brush wear indicator light. When this light glows, STOP USING TH MACHIN
and contact your local Advance distributor to have the motor serviced.
CAUTION!
The motor can be severely damaged if the machine is used with the light glowing.
https://harrissupplyind.com-ToOrderPartsCall608-268-8080

10 - Whirlamatic Operator Manual
TROUBL SHOOTING
MACHIN VIBRAT S
1Pad not centered. Remove the pad, center and reinstall.
2Pad defective - Replace.
SWIRL MARKS
1Pad or brush too aggressive for the floor finish.
2Dirty pad or brush. Check, clean or replace.
R D LIGHT GLOWS
1Worn motor brushes. Have motor brushes replaced by local Advance Distributor.
https://harrissupplyind.com-ToOrderPartsCall608-268-8080

Nilfisk-Advance, Inc.
14600 21st Avenue North
Plymouth, MN, 55447-3408
www.nilfisk-advance.com
Phone: [phone]
Fax: [phone]
©2000 Nilfisk-Advance, Inc.,
Plymouth, MN 55447-3408
Printed in the U.S.A.
https://harrissupplyind.com-ToOrderPartsCall608-268-8080