Nitrous Express 11107 User manual
REMOTE BOTTLE OPENER PN 11107
Congratulations on purchasing the worlds’ rst
and nest remote bottle opener. This opener will
allow you to stay in the comfort of your seat and
open your nitrous bottle. Nitrous Express has
designed the opener to work with NX bottles, but
may be adapted to t all other bottles valves.
The motor has been installed on the main body for
your convenience. The motor can be rotated to 4
different positions if clearance is needed.
1. Remove the bottle from the vehicle, leaving the
nut and nipple intact.. Install the furnished -4 cap
onto the nipple. Open the valve completely. This
will give the proper installation height for the
opener to work without binding.
2. Using a wrench remove the hand wheel from
the top of the bottle valve.
3. Install the adaptor collar around the top of the
bottle valve just below the hand wheel. (See Illus-
tration A.)
2. Install the valve opener gear over the square brass
stem on the top of valve. (See Illustration A
5. Slide the t-bolt clamp over main body; do not
tighten the clamp at this time. (See Illustration
B.)
6. Install the main body over valve and collar making
sure the gear on the drive motor meshes with the
bottle gear correctly. NOTE: If the gears do not
mesh correctly the main body will not set down
properly and damage to the drive motor transmis-
sion is possible.
7. Once the main body is installed correctly, tighten
the t-bolt clamp securely.
8. Wiring your system. (See Illustration C.) Cut the
red and black wires 10 inches from the motor.
Install the seals and male weather pack terminals
on the motor side wires. The wires going to the
activation switch will use female terminal ends.
Slide the terminals into the weather pack housings.
NOTE: CARE MUST BE TAKEN TO INSTALL
THE TERMINALS WITH THE CORRECT
WEATHER PACK HOUSING. IMPROPER
INSTALLATION WILL NOT ALLOW THE
TWO HALVES TO PUSH TOGETHER.
9. Run the remaining red and black wire to the
opener switch mounting location. Follow the
switch socket diagram for proper location of these
wires.
Read all Instructions before beginning!!!!
Caution – EXTREME DANGER – Caution
Do not use or mix any other manufacturer’s products with any Nitrous Express products.
Do not use or mix any Nitrous Express products with any other manufacturer’s products.
THESE INSTRUCTIONS APPLY TO NITROUS EXPRESS PRODUCTS ONLY!
FOR SANCTIONED RACE USE ONLY - NOT FOR SALE OR USE IN CALIFORNIA
10. Route the 12ga. red wire to an ignition switch
controlled 12-volt source. The blue wire will go to
ground. (See Illustration D.)
11. The switch has an internal light for easy location a
night. This lighting terminal will connect to an
interior lighting wire for proper dimming function to
work. To locate this power source consult a wiring
manual for your vehicle. (See Illustration D.)
12. Now to complete the installation reinstall the
bottle, and plug the weather pack connectors
together. Turn the vehicle on and press the close
side of the opener control switch for 2 seconds
and the opener should completely close the bottle
valve. Slowly remove the D-4 cap on the bottle
nipple. A small amount of nitrous will escape, if
the valve is leaking reinstall the cap and cycle the
opener open and closed and recheck for leaks. If
the opener does not completely close the valve a
clutch adjustment may be necessary. See the illus-
trations below for proper clutch adjustment. After
the valve has been veried not to leak reinstall the
supply line. The installation is now complete and
the remote opener is ready to use.
