Nivito Craft CR-1000 User manual

nivitoInstruction Manual
Shower
™
craftshower
CR-1000
5.
COPYRIGHT © Nivito www.nivito.com [email protected] SwedenCOPYRIGHT © Nivito www.nivito.com [email protected] Sweden
nivit
o
™
™
2,5mm 6-angle tool
Connect the pipe
A. B.
C.
Connect the handshower,
Don’t forget the gasket.
nivit
o
™
Match the lines
Insert upper pipe into the lower pipe,
match back lines on two pipes together to be on rectangular,
and lock screw in back pipes to get installation done.
Insert upper parts to upper holder, lower parts two the two brass connectors,
then tighten the screws.
Then all installations are done.
150410
1510
60
1790
100
560
410
OFF
Head shower Hand shower
HOT COLD
OFF
60mm

Shower
Installation
2.
1.
We recommend that you hire a professional plumber.
NOTE: During installation, the pipes until the mixers washed, before the mixer is mounted.
NOTE: When attaching the connection tube (soft PEX tubing) to the supply line
connecting link to be switched off.
BEFORE USE
3.
4.
150mm
Make sure cold and hot water pipes installed at 1050mm height.
Flush the pipes before installation.
Make sure the middle distance btw the two pipes are 150mm and allow 5mm adjustment
Measure the depth of the inner thread of cold and hot water pipes and mark it.
This is to have NO gap left btw the wall and brass connector.
Cut the extra length of the outer thread of the brass connector at marked length.
Fit the two brass connectors to the stainless fixing plate with two holes.
Then tighten the two brass connectors to the cold abd hot water pipes.
900 150
Adjustable in vertical
Measure the distance,
instal the upper holder.
Upper holder
HOT
COLD