NORBERTS MBR-100 Programming manual
A possibility of serious injury, including paralysis or death, is inherent in any activity involving motion or height. Equipment with which this notice is
damaged. Before each subsequent use, re-check equipment stability and settings.
IMPORTANT CONSUMER PRODUCT HAZARD WARNING — PLEASE READ!
CHEERLEADING • STUNTWORKGYMNASTICS • MARTIAL ARTS
ASSEMBLY/INSTALLATION INSTRUCTIONS
MBR-100 MINI BAR RING SET (PAGE 1 OF 2)
BEFORE YOU BEGIN, PLEASE READ THESE IMPORTANT TIPS!
• All connector components MUST be completely and securely shrouded.
• A 4” x 8” panel mat or mini bar-type mat MUST be used to stabilize bar and provide cushioning.
• The area where you will use the bar MUST be at, level and free of any obstructions
• This bar is meant for indoor use; it can be used outside, but should NEVER be left out overnight.
• As with all gym equipment PROPER SUPERVISION IS A MUST!
• NEVER use the bar without rst checking for loose ttings or damage.
FAMILIARIZE YOURSELF WITH ALL SUPPLIED COMPONENTS.
YOU SHOULD HAVE RECEIVED THE FOLLOWING:
1. Two complete strap/ring assemblies, each consisting of two sections of 1.75”
wide nylon webbing connected by a metal slider buckle. Bottom section has
been wrapped around a solid molded thermoplastic hand ring. Hook and loop
strips are sewn to inside surface of top strap to permit adjustment within a
22” to 32” range.
2. Two vinyl shrouds designed to wrap around straps and secure
using hook and loop fasteners.
3. Instruction Sheet.
STEP 1
Loop one strap over bar and through top slot of slider buckle.
Pull leading end of strap up and secure by rmly—and evenly--
pressing entire hook surface to entire loop surface .
Install second strap as described above.
IMPORTANT:
10” OR MORE OF HOOK AND PILE VELCRO MUST BE FULLY AND
SECURELY FASTENED TOGETHER TO PREVENT STRAPS FROM
SEPARATING OR OPENING DURING USE.
READ THIS DOCUMENT AND ALL OTHER ACCOMPANYING PRODUCT DOCUMENTATION THOROUGHLY
BEFORE INSTALLING, USING OR PERMITTING USE OF THIS EQUIPMENT. REQUIRE ALL PERSONS
INTENDING TO USE THIS EQUIPMENT, AS WELL AS THOSE INSTRUCTING OR COACHING USERS,
ASSISTING USERS AND/OR SPOTTING USERS TO READ THIS DOCUMENT THOROUGHLY BEFORE YOU
AUTHORIZE EQUIPMENT TO BE UTILIZED FOR ANY PURPOSE.
A possibility of serious injury, including paralysis or death, is inherent in any activity involving motion or height. Equipment with which this notice is
damaged. Before each subsequent use, re-check equipment stability and settings.
IMPORTANT CONSUMER PRODUCT HAZARD WARNING — PLEASE READ!
CHEERLEADING • STUNTWORKGYMNASTICS • MARTIAL ARTS
ASSEMBLY/INSTALLATION INSTRUCTIONS
MBR-100 MINI BAR RING SET (PAGE 2 OF 2)
READ THIS DOCUMENT AND ALL OTHER ACCOMPANYING PRODUCT DOCUMENTATION THOROUGHLY
BEFORE INSTALLING, USING OR PERMITTING USE OF THIS EQUIPMENT. REQUIRE ALL PERSONS
INTENDING TO USE THIS EQUIPMENT, AS WELL AS THOSE INSTRUCTING OR COACHING USERS,
ASSISTING USERS AND/OR SPOTTING USERS TO READ THIS DOCUMENT THOROUGHLY BEFORE YOU
AUTHORIZE EQUIPMENT TO BE UTILIZED FOR ANY PURPOSE.
STEP 2
After ascertaining both straps are secure, wrap one shroud around
each strap just above ring. Firmly and evenly press together hook
and loop surfaces along shroud’s entire length and width.
IMPORTANT:
SHROUDS MUST COMPLETELY & SECURELY
ENCLOSE CONNECTOR COMPONENTS.
FULLY INSTALLED MBR-100 MINI BAR RING SET
Table of contents
Other NORBERTS Fitness Equipment manuals
