NORSON INDUSTRY EPS146 User manual



EPS146
Instruction Manual (Read before proceeding)
Power:
zPlease charge your Bluetooth speaker fully before its first use.
zOperates using an internal rechargeable Lithium battery.
To charge the battery:
zUsing a Micro USB cable (included), insert the USB power cable into the micro USB
port located on the back of the speaker. Connect the other end of the USB cord into a
powered USB source such as a computer, laptop or USB AC adapter (not included).
zWhen your Bluetooth speaker is charging, the indicator light will turn red.
zOnce your Bluetooth speaker is fully charged, the red light will turn off.
Playing Music Via Bluetooth
zTurn your Bluetooth speaker on by sliding the power switch located on the back of the
speaker to ‘ON’ position.
zThe indicator light will turn blue. This indicates that the speaker is in pairing mode and
is searching for your Bluetooth device.
zMake sure the Bluetooth function on your device is turned on.
zSearch the speaker named, ”BT-09”.
zOnce you have selected the speaker, your device will pair without a password. (If your
device prompts for a password, enter the password”0000”.
zOnce your speaker is paired, the indicator light will begin to flash blue slowly.
zStart playing music on your device. Make sure that you keep your device within a 33
feet range of your Bluetooth speaker.
zAdjust the volume of your device to a comfortable level.
zTurn off the unit when it is not in use.
Universal Speaker Operation:
zFor devices that are not Bluetooth enabled, use the audio input cable (not included)
zInsert the 3.5mm input jack into the “AUX” port
zTurn on the unit by sliding the power switch located on the back of the speaker to ‘ON’
position and start listening to music.
Warning:
zThis is not a toy. Please keep away from small children.
zPlease keep away from water and heat.
zLow battery may cause poor connection and/or may cause the Bluetooth function to
not work.
zDo not over charge the battery.



FCC Statement
zChanges or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
zThis equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the
zinstructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
z-- Reorient or relocate the receiving antenna.
z-- Increase the separation between the equipment and receiver.
z-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
z-- Consult the dealer or an experienced radio/TV technician for help
zThis device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions (1)this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
zThis device has been evaluated to meet general RF exposure requirement.
The device can be used in portableexposure condition without restriction.