Nortek Security & Control Xantech XT-DIG-11 User manual

®
© 2018 XANTECH®is a registered trademark of Nortek Security & Control. 10019377 REV-A010019377 REV-A0
XT-DIG-11 USER MANUAL
User Manual
X T-DIG-11
The Xantech XT-DIG-11 is designed to convert coaxial or optical digital audio signals from one signal type to another. The outputs are simultaneous
so audio can be distributed to multiple locations. The XT-DIG-11 supports 192kHz sample rates for enhanced sound reproduction. This provides the
perfect cost effective solution when connecting a source with only optical audio outputs to a device that has only coaxial digital inputs or vice versa.
Introduction
Key Features
• Converts optical audio to coaxial digital audio or vise versa
• Both optical and coaxial digital outputs work concurrently regardless of input type selected
• Supports sample rates 32 kHz, 44.1 kHz, 48 kHz, 96 kHz and 192 kHz, up to 24-bit resolution
• Plug-and-play
• Small compact size
© 2018 XANTECH®is a registered trademark of Nortek Security & Control.

www.xantech.com
®
XT-DIG-11 USER MANUAL
Panel Description
Package Contents:
Specifications:
• 1x XT-DIG-11
• 1x 5V/1A DC power supply
• 1x Quick reference guide
Audio Input Connectors: 1x Optical digital & 1x Coaxial RCA (SPDIF)
Audio Output Connectors: 1x Optical digital & 1x Coaxial RCA (SPDIF)
Casing Dimensions (W x H x D): 59mm x 48mm x 23mm
Dimensions Including Connections (W x H x D): 59mm x 63mm x 23mm
Shipping Weight: 0.3kg
Operating Temperature: 32°F to 104°F (0°C to 40°C)
Storage Temperature: -4°F to 140°F (-20°C to 60°C)
Power Supply: 5V/1A DC
NOTE: Specifications are subject to change without notice.
Front Panel
Audio input selector switch to select between optical
or coaxial digital input
Optical digital input
Coaxial digital input
Coaxial digital output
Optical digital output
Power port – Use supplied 5V / 1amp DC adaptor
Rear Panel
1
2
3
4
5
6
45 61 32
Maintenance:
Clean this unit with a soft, dry cloth. Never use alcohol, paint thinner or benzene to clean this unit.
Do not substitute or use any other power supply other than the enclosed unit, or a Xantech approved replacement.
Do not disassemble the unit for any reason. Doing so will void the manufacturer’s warranty.
Optical
Select Optical Coaxial
Input
Coaxial
Power
Optical
Output
Coaxial 5V 1A
Optical
Select Optical Coaxial
Input
Coaxial
Power
Optical
Output
Coaxial 5V 1A

®
© 2018 XANTECH®is a registered trademark of Nortek Security & Control. 10019377 REV-A0
XT-DIG-11 USER MANUAL
Optical Digital Coaxial Digital Speaker Cable
1 SOURCE
*Switch set to optical
Select
Example Schematic XT-DIG-11
Optical
Select Optical Coaxial
Input
Coaxial
Power
Optical
Output
Coaxial 5V 1A
© 2018 XANTECH®is a registered trademark of Nortek Security & Control. 10019377 REV-A0

®
© 2018 XANTECH®is a registered trademark of Nortek Security & Control. 10019377 REV-A0
tech support:
[email protected]
main:
1 [phone] - US
1 [phone] - International
1 [phone] - Fax
web:
www.xantech.com
XT-DIG-11 USER MANUAL
FCC Notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION - changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate
the equipment.
CANADA, INDUSTRY CANADA (IC) NOTICES
This Class B digital apparatus complies with Canadian ICES-003.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
CORRECT DISPOSAL OF THIS PRODUCT
This marking indicates that this product should not be disposed with other household wastes. To prevent possible harm to the environment or
human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used
device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for
environmentally safe recycling.
Certifications
© 2018 XANTECH®is a registered trademark of Nortek Security & Control. 10019377 REV-A0