Nortek Security & Control Linear BluePass 820-00001 User manual



BluePass2‐N‐1Multi‐TechReader–InstallationGuide
820‐00001

Copyright © 2018 Nortek Security and Control LLC 1 10020730 X5

ThispageisintendedforinstalleruseintheinstallationoftheBluePass2‐N‐1Multi‐TechReader.

Introduction
Thisguidewillwalkaprofessionalinstallerthroughthe
stepsneededtoattacha2‐N‐1BluePassMulti‐Tech
Readertoanaccesscontrolpanel.The2‐N‐1supports
125KHzproximityfobsandcardsaswellasLinear
BluePassmobilecredentials.Pleasereviewthe
informationbelowtoensurethereaderisinstalled
quicklyandproperly.
WARNING:DONOTconnectthereaderupwith
energizedwiresuntilinstructedtodoso.
Grounding
 Theshieldmustruncontinuouslyfromthereaderto
thepanel.Atthepanel,thereaderground,shield
line,andearthgroundmustbeconnectedtogether
atasinglepoint.
o Donotgroundtheshieldlineatthe
readerend,asthiswillcreatea
potentialgroundloop.
Power
 Anon‐switchingpowersupplyatthepanelis
recommendedtopowerthereaderforthehighest
noiseimmunityandbestperformance.
 ForUL294Compliance,thereadersshallbe
connectedtoaclasstwopowerlimitedpower
supplyorcontrolpaneloutput.
 Therecommendedwiregaugeis24AWG.
Voltage
 Theminimumreadervoltagerequiredis+6VDCtoa
maximumof+16.0VDC,and12.0VDCis
recommended.
 Thereaderwillrequire100mA(typical@12VDC)in
standardmode,220mA(typical@12VDC)in
advancedmode.
 Thereaderisin“standard”modebydefault.
“Advanced”modecanbeconfiguredviain‐app
settingsusingtheBluePassapp.
Connection
 ConnectionsmustbeinaccordancewithNFPA70.
DONOTconnecttoareceptaclecontrolledbya
switch.
MountingtheReader
 Iftheunitisusedtocontroladoororpedestrian
gate,locatetheunitasnearaspracticaltotheentry
point.Iftheunitismountedonorinawalladjacent
totheentrypoint,besurethewallissturdy.The
repeatedshockandvibrationfromaslamming
accessdoororspring‐loadedpedestriangatemust
beisolatedfromtheunit.
 Nevermountthereaderdirectlyonamovingdoor
orgate.
 Chooseawell‐litlocationnearthecontrolled
opening.Wiringaccessforpower,network,and
earthgroundmustbeavailabletothemounting
location.
Mounting
 BoththeMullionandSingle‐gangreaderscanbe
mountedonawalloranysuitableflatsurface.
MobileDeviceandSoftware
 The2‐N‐1Multi‐TechReaderutilizesBLEversion4.0.
 Thereaderistobeusedinconjunctionwiththe
BluePassMobileApp(Version1.0orhigher).
 Inorderforthereadertofunctionproperly,the
mobiledevice’ssoftwaremustbeuptodate.
 iOSDevices:iOS10.0orhigher
 AndroidDevices:v5.0(Lollipop)orhigherand
peripheralmodesupported.
 Refertohttp://bluepass.ioorusetheQRcode
forobtainingfullversionsoftheUserand
Installationmanuals.






BluePass2‐N‐1Multi‐TechReader–InstallationGuide
820‐00001

Copyright © 2018 Nortek Security and Control LLC 2 10020730 X5


ReaderWiring

Wiegand
Conductor Purpose
Red DC +6-16 VDC
Black Ground
Green Data 0
White Data 1
Purple Red LED
Orange Beeper
Yellow Card Present
Blue Green LED
Drain Shield Ground
CurrentDraw:100mA(typical@12VDC)

UL294PerformanceLevels

MODEL #
ACCESS CONTROL
LINE SECURITY
LEVEL
DESTRUCTIVE
ATTACK LEVEL
ENDURANCE
LEVEL
STANDBY
POWER LEVEL CONDITIONS
BLUEPASS 2-N-1
MULTI-TECH
READER Level I Level I Level III Level I N/A
Certifications
 FCCComplianceStatement:ThisdevicecomplieswithPart15oftheFCCrules.Operationissubjecttothe
followingtwoconditions:
 Thisdevicemaynotcauseharmfulinterference.
 Thisdevicemustacceptanyinterferencereceived,includinginterferencethatmaycauseundesired
operation.