Read this manual carefully before use
and keep it safe for future reference.
Warnings
- Avoid eye injury. Do not stare directly into the light beam or point it directly into the eyes of
any person or animal. Doing so for more than a few seconds could cause retinal damage.
- When powering on the ashlight, make sure to point it down or away from you and anyone else.
- The surface of this product can become hot after prolonged use. Be careful when touching it and
make sure to keep it away from anything ammable or combustible.
- Never leave the ashlight unattended when it is powered on.
- If the ashlight is used less than once a month, remove the batteries to avoid leakage or corrosion.
- Before long-term storage, remove the batteries and store them in a cool and dry place.
- Any battery may leak harmful chemicals. To avoid risk of injury, do not let any material leaked from a
battery come in contact with eyes or skin.
- Do not expose batteries to excessive heat or direct sunlight. The battery may rupture or explode if put
in a re or exposed to excessive heat.
- Only use the included battery.
- Install the batteries in the proper orientation as indicated by the instructions in this manual.
- This product is water resistant, not waterproof. Don’t leave it outside in heavy rain.
- If soaked in water, immediately dry the ashlight and remove the battery. Dry thoroughly and install a
new battery.
- Do not attempt to disassemble or repair this product. It is dangerous and will also void the warranty.
- Keep this product away from children. Do not leave children unattended near this product.
- Make sure that this product is intact and that there are no missing parts.
- To avoid damage to this product, be careful not to overtighten or improperly x any of the threaded
ttings.
First time use
- Unscrew the end cap in a counter-clockwise direction.
- Remove the battery protection plate placed between the battery negative pole (-) and end cap.
- Insert the battery again with the positive pole (+) pointing toward the light head. Ret the end cap.
- Remove the protection lm from the glass front.
- Open the rubber protection on the end cap to access the USB connectors.
- Fully charge the battery before rst time use.
- Trace has three light modes. High, medium and low. To change he brightness simply push the on/o
switch the number of times needed.
Charging the battery
- To charge the battery use the included USB cable. Plug the USB-C cable (male) into the ashlight and
connect the USB-A (male) to a computer or a universal USB adaptor.
- While charging a red indicator light near the charging port will blink until fully charged. The red
indicator light will be permanently lit when fully charged.
- To fully charge an empty battery takes approximately 5 hours.
- Always close the rubber protection on the tail cap properly after charging.
Power bank
- The ashlight may be used as a power bank.
- Use your own charging cable or the included USB cable. Plug the USB-A cable (male) into the
ashlight and the other end to your device.
- When the ashlight is used as a power bank the blue indicator light will be permanently lit.
Cleaning instructions
- Wipe spills and stains immediately.
- Clean using a soft, dry cotton cloth.
- If a deeper clean is required, a cotton cloth moistened with lukewarm water can be used.
Always wipe with a dry cotton cloth to remove any residue.
- Avoid applying strong cleaning agents as it may damage the surface.
Trace 4 W LED, 4400 K, IP44, 100 lm / 240 lm /
360 lm step dimmable, Power bank,
3.7V Lithium Ion rechargable battery
